Motorola HT-1000 Service Manual page 40

F2
Transmitter
Alignment
Menu
F2 - Reference Oscillator
F3 - Tx Power
F4 - Tx Dev Balance
F5 - Tx Dev Limit
F6 - Tx Dev Reference
F7 - Tx VCO Crossover
Note: F2 = Function Key 2
18
Service
Menu
F3
Receiver
Alignment
Menu
F2 - Front End (VHF/UHF)
F3 - Rated Audio
F4 - Squelch (25/30 kHz)
F5 - Squelch (20 kHz)
F6 - Squelch (12.5 kHz)
F7 - RX VCO Crossover
Figure 2 RSS Service Menu Layout
All service and tuning procedures are performed from the SERVICE
menu, which is selected by pressing F2 from the MAIN MENU.
Figure 2 illustrates how the RSS SERVICE screens are organized.
All SERVICE screens read and program the radio codeplug directly; you
do NOT have to use the RSS GET/SAVE functions to use the SERVICE
menus. You will be prompted at each screen to save changed values
before exiting the screen. RSS references in this manual are to
HT 1000 / JT 1000 RSS. Some slight differences may be noted it you are
using the MTS/MTX RSS.
Do NOT switch radios in the middle of any
!
SERVICE procedure. Always use the EXIT key to
return to the MAIN menu screen before
disconnecting the radio. Improper exits from the
SERVICE screens may leave the radio in an
C a u t i o n
improperly configured state and result in
seriously degraded radio or system performance.
The radio contains internal test modes that can be accessed from the
RSS. The test modes permit the service technician to easily select
various frequency, modulation, and transmit power combinations to
verify proper operation of the radio. The test modes can be used to
check both transmit and receive operation. From the Service Menu
press F6 to navigate to the TEST MODE screen.
The SERVICE screens introduce the concept of the "softpot", an analog
SOFTware controlled POTentiometer used for adjusting all transceiver
alignment controls.
F4
Signalling
Alignment
Menu
F2 - DTMF
F3 - Trunking
F4 - MDC 1200
Mode
Menu
MAEPF-22857-A
F6
Test