Features Of Your Iron; Temperature Control - Morphy Richards Precise Steam Plus Instructions Manual

40730MCZ Rev1:9225 47507 MEE pump - Jon
FILLING
A
1 Make sure that the iron is not
plugged in, then set the steam to
dry iron selector switch ⁄ to
the '0' position before filling the iron
with water.
2 Lift up the filler cap and fill the tank
‡ with water through the filling hole
‰, using the beaker provided
(300ml). A Â After filling replace
the filler cap. In hard water areas
the use of distilled or demineralised
water is recommended.
WARNING: Never use battery
topping up fluid or water
containing any substances like
starch, or sugar, or defrosted
water from a refrigerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your iron
with tap water always use the
beaker provided. Never fill
directly under the tap.
TEMPERATURE
CONTROL
B
Plug in the iron and switch on. Set
the temperature control dial ¤ to
the temperature required, but don't
start ironing immediately.
If you wait a few minutes, the iron
will stabilise at the required setting.
Your Morphy Richards iron is fitted
with an indicator light fl which will
go on and off while you are ironing.
This is perfectly normal as it shows
that the iron is maintaining the heat
setting you have chosen.
It is always a good idea to begin
with cool fabrics and work up to
higher settings.
An iron heats up quicker than it
cools down so you'll save time and
electricity.
10/10/08 16:02
FEATURES OF YOUR
IRON
Temperature indicator
light
The indicator light fl shows that
the iron is warming up. When the
required temperature is reached the
light will go out and will cycle on-off
during operation.
Dry ironing
You can use your iron as a dry iron
only. Make sure the steam to dry
iron selector switch ⁄ is set to the
symbol.
Any temperature setting may be
used depending on the garment.
The spray feature may be used
provided there is water in the tank
(see filling section). You do not need
to put any water in the tank when
dry ironing only.
Spray
C
Press the spray button › and aim
the spray of water at stubborn
creases. You can do this whilst dry
ironing providing there is water in
the tank. When using the water
spray it may be necessary to push
the button a few times to get the
spray pump primed.
Automatic variable
steam
D
Fill the iron with water as described
in the filling section, and insert the
plug into the electrical socket.
1 Set the steam to dry iron selector
switch to steam.
2 Select the temperature required by
turning the temperature control dial
¤ to the desired setting. The
amount of steam required is
automatically selected and is
displayed in window ‹.
Press the shot of steam button fi
to obtain a burst of extra steam for
ironing out creases in heavy
material such as denim.
Page 5
A
B
C
D
g
5