HID Mercury MP1502 Installations And Specifications page 8

Table of Contents

Advertisement

2.1.1 Jumpers and jacks
The MP1502 processor hardware interface is configured using jumpers to setup the reader port power and end of line
termination.
Jumpers
Set at
J1200
N/A
J1503
OFF
ON
OFF
J1501
ON
OFF
J1502
ON
J1300
N/A
J503
Reader power select. See caution below.
12V
PASS
J1100
N/A
J1400-1
N/A
J1400-2
N/A
J1400-3
N/A
J1400-4
N/A
J1002
Super capacitor or battery backup real time clock.
OFF
ON
1. Observe polarity connection to LED. External current limiting is not required.
Caution: Install jumper J503 link 1 and 2 when input voltage (VIN) is greater than 17 V DC for 12 V
regulated reader output.
PLT-07611 , A.0
Description
10-Base-T/100Base-Tx Ethernet connection (Port 0)
RS-485 EOL Terminator is OFF
RS-485 EOL Terminator is ON
Reader 1 RS-485 EOL Terminator is OFF (Non-OSDP readers)
RS-485 EOL Terminator is ON (OSDP readers)
Reader 2 RS-485 EOL Terminator is OFF (Non-OSDP readers)
RS-485 EOL Terminator is ON (OSDP readers)
Micro USB port (2.0)
12 V DC at reader ports
VIN "Pass Through" to reader ports
microSD card
1
Remote Status LED #1.
1
Remote Status LED #2.
1
Remote Status LED #3.
1
Remote Status LED #4.
Backup battery is OFF.
Backup battery is ON. Default J1002 link 1 and 2 super capacitor real time clock back up. Link
2 and 3 battery back up. See
Memory and real time clock backup battery
6
HID Mercury MP1502 Controller
Installation and Specifications
May 2024

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mercury MP1502 and is the answer not in the manual?

Table of Contents

Save PDF