Download Print this page

TRAPP HTX-6000 Instruction Manual page 44

Hedge trimmer with gasoline engine

Advertisement

Available languages

Available languages

Problem
The engine doesn't start.
When idling, the engine runs very fast.
The engine doesn't reach maximum
capacity.
44
Useful Suggestion
Cause
1. Empty tank.
2. The engine is flooded.
3. Dirty spark plug (carbon residue
on electrodes), distance too great
between electrodes.
4. Dirty carburetor or carburetor
ejectors.
5. Spark plug connector or ignition
cable damaged.
6. Dirty air filter.
1. Cold engine
1. Dirty spark plug (carbon residue
on electrodes), distance too great
between electrodes.
2. Dirty carburetor or carburetor
ejectors.
3. Dirty air filter.
4. Dirty exhaust.
5. Dirty cylinders, pistons, piston rings. 5. Replace cylinder, piston or piston
6. Poor fuel mixture (too much oil).
7. Poor ignition.
www.trapp.com.br
Troubleshooting
1. Fill the tank.
2. Turn of the On/Off Switch and try to
start up several times, and if necessary
remove the spark plug and dry it.
3. Clean the spark plug, check the
measurement of the electrode and
adjust the opening to 0-0.7 mm.
4. Clean the carburetor and remove it.
5. Replace.
6. Clean or replace air filter.
1. Warm up slowly, turn off choke, if
necessary set to slow.
1. Clean the spark plug, check its
thermal value and replace it if
necessary. Configure 0.6-0.7 mm.
2. Clean the carburetor. Remove it.
3. Clean.
4. Remove exhaust tube, clean and
remove carbon residue.
rings, grinding cylinder and piston,
install.
6. Follow mixing instructions and use
good-quality oil and gas.
7. Adjust distance in ignition module
(0.6-0.7 mm).

Advertisement

loading
Need help?

Need help?

Do you have a question about the HTX-6000 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Related Products for TRAPP HTX-6000