TRAPP HTX-6000 Instruction Manual page 41

www.trapp.com.br
After every
Before each
20 hours of
use
operation
Make sure all nuts and
Clean the air filter.
bolts are tight.
Check for any fuel leaks
in the fuel tank or in the Clean the fuel filter.
hoses.
Clean the fairing and
spark plug; if necessary,
Clean the engine-cooling
adjust the
vanes and cutting blade.
gap to between 0.6 and
0.7mm.
Nota: we recommend taking the Hedge Trimmer to a Trapp authorized technical assistance center for
maintenance to avoid loss of warranty.
Note: The period indicated on the maintenance table may vary according to working conditions and
type of fuel mixture.
Under no circumstances should you disassemble

your trimmer. Doing so can void the warranty.
Always be sure to turn off the engine when

performing any maintenance or inspection
procedure.
When sharpening, removing or replacing the

blade, make sure to use thick and resistant gloves,
and only use proper tools and equipment, in order
to avoid injury.
Anti-Vibration System
If the machine vibrates excessively, you should check
the springs.
Image for illustrative purposes only
This activity should be performed at Trapp Authorized
Assistance..
After every
50 hours of
operation
Replace the spark plug Replace the spark plug
with an equivalent with
model. model.
Clean the air filter. Replace the Air filter.
Clean the fuel tank and
electrode Replace the fuel filter.
clean the carburetor.
After every
After every
100 hours of
300 hours of
operation or
operation
every 6 months
Replace the spark plug
an equivalent cable and the starter
cord.
Replace the fuel hose.
Clean the carburetor
and decarbonize the
engine.
ATTENTION!
The anti-vibration system reduces the
vibration the operator feels while working,
for which the springs need to be kept in good
condition. Periodically check the condition of
the springs, and replace them if need be.
Air Filter
Release the cap from the air filter (1) by removing
the screws (3), next remove the filter (2) and clean
it. If the foam filter (2) is dirty, carefully wash it with
lukewarm water containing neutral detergent. Dry
the filter completely and moisten it with 20W50 oil
before returning it to its casing. If the filter is warped
or damaged, replace it with a new one.
Image for illustrative purposes only
After
Maintenance
Check the installation
after performing
maintenance.
Make sure all nuts and
bolts are tight.
Check for any fuel
leakage.
3
2
1
41