Rimage AutoEverest Setup And Installation Manual page 2

3
Setup your Everest Printer
Place the printer on the AutoPrinter so that the plastic printer feet
slide into the slots on the printer plate.
Slots
Printer Plate
4
Connect the Cables
Important! Make sure the power switch on the AutoPrinter is in
the Off position. Do not power on the AutoPrinter until prompted
to do so during the CD Designer Software Suite installation.
a. Connect the
printer cable
from the
AutoPrinter
to the Everest
printer.
b. Connect the
short power
cord from the
AutoPrinter
to the Everest
printer.
110660-001_I
5
Install the CD Designer Software Suite
Before you can operate an AutoEverest AutoPrinter, you must install
the Rimage software.
Note: Unless otherwise indicated, all Windows navigation statements
are Microsoft Windows 10 paths. Other operating systems' navigation
paths may differ slightly.
a. Insert the Rimage CD Designer Software Suite disc that shipped
with the AutoPrinter into the PC disc drive.
b. Open the file named cddsetup.exe.
c. Follow the prompts to install the CD Designer software.
6
Test and Verify
Run a three-disc test job to verify that the system is operating
correctly.
c. Connect the USB
cable from the
7
Everest printer to Learn more
the control center
•
(PC).
•
d. Connect the
power cord
from the
AutoPrinter
to a suitable
electrical outlet.
For information about operating and maintaining the AutoEverest
system, refer to the Rimage AutoEverest User Guide.
For additional support and product information, go to
www.rimage.com/support.
Copyright © 2018 Rimage Corporation Page 2