Care And Cleaning; To Clean Individual Components; To Clean Without Disassembly - KitchenAid KSB585CR Instructions And Recipes Manual

The Blender pitcher, locking collar and
blade assembly can be easily cleaned
as individual components or together
without disassembly.
• Clean the Blender thoroughly after
every use
• Do not immerse the Blender base or
cord in water
• Do not use abrasive cleansers or
scouring pads

to clean Individual components

1. Lift the pitcher assembly in a straight,
upwards motion off the Blender base.
Then, while holding locking collar,
rotate pitcher counterclockwise, two
clicks, to separate locking collar and
blade assembly, and sealing ring from
the pitcher. Wash components with
soapy water. Rinse and wipe dry.
NotE: Pitcher can be placed in the
bottom rack of an automatic dishwasher.
The lid, ingredient cup, locking collar and
blade assembly, and sealing ring can be
put in the top rack. For best results, hand
washing is recommended.
Pitcher
sealing
Ring
Locking
collar
and Blade
Assembly
2. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.

care and cleaning

to clean Without Disassembly

2. To clean the lid and ingredient cup,
3. Wipe the Blender base and cord with
13
1. Put the pitcher on the Blender base,
fill half full with warm (not hot) water,
and add 1 or 2 drops of dishwashing
liquid. Put the lid on the
the STIR speed setting, and run the
Blender for 5 to 10 seconds. Remove
the pitcher and empty contents. Rinse
with warm water until clean.
wash in warm soapy water, then rinse
and dry thoroughly.
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.
pitcher, press