Masterbuilt 20051213 Owner's Manual page 5

WARNINGS
• Soapy Water Test MUST be performed each time gas cylinder is connected to burner/hose or each time it
is used.
• Soapy Water Test MUST be performed outdoors in well ventilated area.
• When performing Soapy Water Test keep smoker away from open fl ames, sparks or lit cigarettes.
• Smoker is designed to work with propane gas only. Only use gas cylinders marked propane with this unit.
This product will NOT operate with natural gas.
• Never use an open fl ame to test for gas leaks.
PREPARATION:
• Remove any cookware from smoker.
• Make sure regulator and gas cylinder valve are in OFF position.
• Prepare soapy water solution: (1) part dish washing liquid (or more if desired), (3) parts water.
• Apply soapy water solution to gas cylinder valve, regulator and hose length up to burner.
Apply solution to
gas cylinder valve
TESTING GAS VALVE:
• Turn gas cylinder valve ON and watch for bubbles. DO NOT LEAVE GAS ON MORE THAN
12 SECONDS. If bubbles appear, stop, turn gas cylinder OFF and retighten fi tting. Repeat test.
TESTING REGULATOR AND HOSE:
• AFTER gas cylinder valve has passed Soapy Water Test, turn gas cylinder valve ON, open regulator
control valve one full turn and check for bubbles at valve location, along full length of hose and at burner
connection. DO NOT LEAVE GAS ON MORE THAN 12 SECONDS. If bubbles appear, stop, turn
regulator valve OFF, turn gas cylinder OFF and retighten the connection that is leaking gas. If hose is
source of leak, STOP, do not use unit. Hose must be replaced.
• When test is complete, and there are no leaks, wait minimum of 5 minutes for gas fumes to diminish
before lighting cooker.
DURING ANY PORTION OF SOAPY WATER TEST IF BUBBLES CONTINUE TO
APPEAR, STOP, DO NOT USE UNIT. CONTACT LOCAL PROPANE DEALER OR
Note: Use 20LB (9kgs) gas cylinder that has a protective collar with this unit.
3
SOAPY WATER TEST WARNINGS & PROCEDURES
Apply solution to hose regulator
and the full length of the hose
MASTERBUILT CUSTOMER SERVICE @ 1-800-489-1581.
Cylinder NOT included with this unit.
Apply solution underneath control
panel where burner and hose are
connected
(Smoker shown on back for clarity only)
Failed test will present bubbles as
shown below.