PCB Piezotronics IMI SENSORS ICP EX604 Series Installation And Operating Manual page 7

4
PCB Piezotronics Inc. claims proprietary rights in
the information disclosed hereon. Neither it nor any
reproduction thereof will be disclosed to others
without the written consent of PCB Piezotronics Inc.
SCHEDULE DRAWING
NO MODIFICATIONS PERMITTED
WITHOUT REFERENCE TO THE
NOTIFIED BODY
B
7.) NE PAS DÉBRANCHER LORSQU'UN EMPLACEMENT DANGEREUX EST PRÉSENT
6.) DO NOT DISCONNECT WHEN HARZARDOUS LOCATION IS PRESENT
5.) NE PAS DÉBRANCHER LORSQUE ÉNERGÉ
4.) DO NOT DISCONNECT WHEN ENERGIZED
3.) EQUIPMENT CONSISTS OF TRANSIENT PROTECTION DEVICE TO BE SET AT A LEVEL NOT EXCEEDING
A
140% OF RATED POWER SUPPLY VOLTAGE (30V)
2.) FOR GUIDANCE ON CANADIAN INSTALLATION, REFER TO CEC PART I. FOR
GUIDANCE ON U.S. INSTALLATION, INSTALL IN ACCORDANCE WITH NEC
[ANSI/NFPA70] AND [ANSI/ISA RP12.6].
1.) CERTIFIED BY THE APPROPRIATE APPROVAL AUTHORITY FOR CONNECTION
TO THE FOLLOWING AREAS:
NORTH AMERICA:
CLASS I, DIV 2, GROUPS A,B,C,D T4
EUROPE:
Ex nA IIC T4 Gc
4
3
POWER
SUPPLY
POWER
SUPPLY
POWER
SUPPLY
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES
DECIMALS
XX
XXX
XXXX
ANGLES ± 2 DEGREES
FILLETS AND RADII .003 - .005
HEX DIMENSIONS ARE:
≤ .5 + .000 / - .003
> .5 + .000 / - .005
INTERNAL THREAD DEPTH MIN.
REMOVE ALL BURRS
SHARP = R.000 - R.003
3
2
NON-HAZARDOUS / SAFE AREA
APPROVED
OR DIV 2 / ZONE 2
POWER SUPPLY/
SIGNAL CONDITIONER
X-AXIS
X-AXIS
Y-AXIS
Z-AXIS
GND
GND
SHIELD
SHIELD
Y-AXIS
GND
SHIELD
Z-AXIS
GND
SHIELD
DRAWN
X  .05 KSR 2/11/20
 .01
 .005
 .0005 TITLE
APPROVAL
INTERCONNECTION
DIV 2, ZONE 2
2
1
REVISIONS
REV DESCRIPTION
-SEE SHEET 1-
TRANSDUCER
CABLE
CHECKED ENGINEER
KSR 2/11/20 GGS 2/11/20
3425 WALDEN AVE. DEPEW, NY 14043
(716) 684-0002 E-MAIL: sales@pcb.com
DWG. NO.
CODE
68438
IDENT. NO.
52681
NONE
SCALE: SHEET
1
DIN
B
A
2 OF 2