PCB Piezotronics IMI SENSORS ICP EX604 Series Installation And Operating Manual page 35

IECEx Certificate
of Conformity
M1@)VL
P - MiTh4
Ceiificate No,: iECEx ETL 18.0017X Page 2 of 4
Date of issue: 2019-12-18 issue No: 1
Manufacturer:
IMI Sensors a Division of PCB Piezotronics
3425 Walden Ave
Depew, NY 14043-2417
USA
United States of America
Additional
manufacturing
locations:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with
the lEO Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was
assessed and found to comply with the lECEx Quality system requirernents.Thls certificate is granted subject to the conditions as set out in
lECEx Scheme Rules, 1ECEX 02 and Operational Documents as amended
STANDARDS:
The equipment and any acceptable variations to It specified in the schedule of this certificate and the identified documents, was found
to comply with the following standards
iEC 60079-0:2011 Explosive atmospheres
-
Part 0: General requirements
Edltion:6,0
lEO 60079-11:2011
Explosive atmospheres
-
Part 11: Equipment protection by Intrinsic safety 'I'
Editlon:6.0
lEC 60079-15:2010 Explosive atmospheres
-
Part 15: Equipment protection by type of protection n
Eclltion:4
This Certificate does not indicate compliance with safety and performance requirements
other than those expressly included in the Standards listed above,
TEST & ASSESSMENT REPORTS:
A sample
(
s) of the equipment listed has successfully met the examination and test requirements as recorded In:
Test Reports:
US/ETUExTR180022/00 USJETL/ExTR18.0022/01
Quality Assessment Report:
NL/DEK/QAR14.0004/03