Sony Imx571 Sensitivity; 16Bit Adc And Roi; Ddr3 Buffer; Binning - TOUPTEK PHOTONICS ATR2600C User Manual

2.2 Sony IMX571 Sensitivity

The sensor G Sensitivity of ATR2600C is 484.6mv with 1/30s. Its spectral sensitivity is shown in Figure 2.

2.3 16bit ADC and ROI

ATR2600C has built in 16bit ADC. It also has 12bit output mode for hardware binning and smaller resolution. The camera
also supports hardware ROI, and the smaller the ROI size is, the higher the frame rate is.
Table 2 shows the frame rate of ATR2600C in 16/8bit mode, USB3.0 / USB2.0 data transfer interface at different resolutions:
Table 2 ATR2600C Frame Rate at Different Resolution/Data Bit/Data Transfer (USB3.0/ USB2.0)

2.4 DDR3 Buffer

The ATR2600C camera has a 512MB (4Gb) DDR3 buffer, which helps maintain the stability of data transmission, and
effectively reduce the amp-glow caused, because image data can be temporarily buffered without being sent hastily to the
receiver.

2.5 Binning

ATR2600C supports digital binning from 11 to 88 in either stacking or averaging method, and hardware binning from 11
to 33 in averaging method. Hardware pixel binning is much faster than software binning.

2.6 Conversion Gain Switch

HCG
ATR2600C support
Figure 2 IMX571 Spectral Sensitivity Characteristic
Bit & Interface
FPS
Resolution
6224 * 4168
6224 * 4168 (Low Noise)
3104*2084
2064*1386
LCG
and mode switch, the Gain ratio is 3.01.
ATR2600C(ATR3CMOS26000KPA) User Manual
16bit ADC 8bit ADC
USB3.0 USB2.0 USB 3.0
6.8 0.6 14.2
3.4 0.3 NA
28 3.6 37.1
63 8.5 110
3
USB 2.0
1.2
NA
7.0
15.7