Download Print this page
Consort SLPB Installation & Control Manual

Consort SLPB Installation & Control Manual

Wireless controller

Advertisement

Quick Links

SLPB Controller
ver3
Installation & Control Guide for SLPB
Wireless Controller
All electrical appliances produced by the Company are guaranteed for one year against faulty materials or
workmanship. This applies only if the appliance has been used for purposes in accordance with the instructions
provided and has not been connected to an unsuitable electricity supply, or subject to misuse, neglect, damage
or modified or repaired by any person not authorised by us. This guarantee is offered to you as an extra benefit and
does not affect your legal rights.
The correct electricity supply voltage is shown on the rating label attached to the appliance.
Reasonable care has been taken to ensure that this guide is accurate at the time of printing. In the interest of
progress the Company reserve the right to vary specifications from time to time without notice.
C
H
USTOMER
ELPLINE
Should you need any advice on the use of your new Consort product, please contact our Helpline:
Consort Equipment Products Limited
Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT
Tel: 01646 692172 Fax: 01646 695195 Email: technical@consortepl.com Web: www.consortepl.com
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm
BS EN ISO 9001 Registered Company No FM12671
1
13984067 Iss 03

Advertisement

loading
Need help?

Need help?

Do you have a question about the SLPB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Consort SLPB

  • Page 1 Company reserve the right to vary specifications from time to time without notice. USTOMER ELPLINE Should you need any advice on the use of your new Consort product, please contact our Helpline: Consort Equipment Products Limited Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT Tel: 01646 692172 Fax: 01646 695195 Email: technical@consortepl.com Web: www.consortepl.com...
  • Page 2: Wireless Controller

    2. Getting to know your SL wireless controller The SLPB controller can control multiple heaters within its RF range. The RF range can be extended if necessary, see product code SLEXT. The controller has 3 operating modes. The required mode must be set prior to the installation by using the switches located on the back of the controller.
  • Page 3 4 Basic Mode For basic mode, the switches are set as shown below. Heating Stand-By Active Controller functionality in basic mode: Press button to activate heating, press button again to set controller to stand-by. When heating is active, the 4 light indicators are green. After pressing the button, heating is set to stand-by; the indi- cators will change from green to red for 4 seconds and then go off.
  • Page 4 8. Choosing a position in a room The SLPB controller should be fixed to the wall. Avoid areas with draught or direct sun. Do not position the controller above or close to the heaters or other heat sources. Damp areas or areas where SLPB can be mechanically damaged should also be avoided.
  • Page 5: Declaration Of Conformity

    BS EN 60335.1 (2012) • ETSI EN 301 489-1 V2.2.2 (2019) • BS EN 60335.2.30 (2009) • ETSI EN 301 489-3 V2.1.1 (2019) • ETSI BS EN 303645 • SLPB UMBER ESCRIPTION PPLIANCE O’S ESPONSIBLE ERSON AVID ULLIVAN OSITION PERATIONS...