Consort SLPIR Installation & Control Manual

Table of Contents

Download this manual

SLPIR C

ONTROLLER

Installation & Control Guide for SLPIR

Motion Detection Wireless Controller

All electrical appliances produced by the Company are guaranteed for one year against faulty materials or

workmanship. This applies only if the appliance has been used for purposes in accordance with the instructions

provided and has not been connected to an unsuitable electricity supply, or subject to misuse, neglect, damage

or modified or repaired by any person not authorised by us. This guarantee is offered to you as an extra benefit and

does not affect your legal rights.

The correct electricity supply voltage is shown on the rating label attached to the appliance.

Reasonable care has been taken to ensure that this guide is accurate at the time of printing. In the interest of

progress the Company reserve the right to vary specifications from time to time without notice.

USTOMER

ELPLINE

Should you need any advice on the use of your new Consort product, please contact our Helpline:

Consort Equipment Products Limited

Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT

Tel: 01646 692172 Fax: 01646 695195 Email: technical@consortepl.com Web: www.consortepl.com

Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm

BS EN ISO 9001 Registered Company No FM12671

13984111 Iss 01

Table of Contents

Need help?

Do you have a question about the SLPIR and is the answer not in the manual?

Page 1 Company reserve the right to vary specifications from time to time without notice. USTOMER ELPLINE Should you need any advice on the use of your new Consort product, please contact our Helpline: Consort Equipment Products Limited Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT Tel: 01646 692172 Fax: 01646 695195 Email: technical@consortepl.com Web: www.consortepl.com...
Page 2 2. Getting to know your SL wireless controller The SLPIR controller is designed to control multiple SL heaters or SL receivers within the RF range. The RF range can be extended if necessary *see product code SLEXT. The controller has 2 operating modes. The required mode must be set prior to the installation by using the switches located on the back of the controller.
Page 3 4. Presence detection with Time and Temperature Control Temperature control for the comfort period To enable temperature control, the switch 1 is set to ‘ON’ position as shown below. The temperature control is only active after motion detection and will end after the set time period ends. After the set time period ends, the tem- perature is allowed to fall.
Page 4 8. Choosing a position in a room The SLPIR controller should be fixed to the wall or ceiling. If installed on the wall it should be positioned at 1.5 metres from the floor pointing towards the detection area. If mounted on the ceiling the orientation to achieve the best detection should be used.