Prior To Initial Start-Up; Starting Up - Setting The Temperature - JUNO JKI 4035 Operating Instructions Manual

Prior to Initial Start–Up
1. Please clean the appliance interior and all accessories prior to initial
0
start-up (see section: "Cleaning and Maintenance").

Starting Up - Setting the Temperature

The temperature regulator is in the
refrigerator compartment on the
upper right. It is also the ON/OFF-
switch.
Position "0" = Refrigeration off
Position "1" = Warmest interior temperature
Position "6" = Coldest interior temperature
0 1. Plug the mains plug into the mains socket.
2. Set the required temperature by turning the temperature regulator.
The inside light goes on. The compressor starts and then runs automa-
tically.
3. If you want a higher or lower temperature, turn the temperature regu-
lator to a warmer or cooler setting respectively.
Note: When the setting is changed, the compressor does not start
immediately if automatic defrosting is currently taking place.
Goods to be refrigerated can be loaded immediately after switching on,
3
because the storage temperature in the refrigerator is quickly reached.
Note: From a food science point of view, +5 °C should be considered
3
cold enough as a storage temperature.
The following effects are of significance in respect of the interior tem-
perature:
– Ambient temperature;
– Quantity and temperature of the food stored;
– Frequency with which the door is opened and how long it is left
open
– A defect in the appliance.
The temperature regulator setting may therefore need to be adjusted to
suit the specific conditions.
36