Installation; Electrical Connection - JUNO JKI 4035 Operating Instructions Manual

Installation option 2:
Operation of E-appliances is pos-
sible even without a ventilation
opening in the furniture plinth.
The fresh air able to enter under
the appliance is sufficient for
ventilation. The function and life
of the appliance are not
impaired. The warmed air must
be able to be exhausted upwards
through the air shaft (min. 200
2
cm ) on the furniture back. If the
appliance is ventilated without a
plinth opening, however, the energy consumption may differ from that
specified in the brochure.
Important note! In order not to impair the function of the appliance,
never cover or obstruct the ventilation openings.

Installation

See installation instructions supplied.
Please check whether, after installing your appliance and especially
after rehingeing the door, the door seal seals right round. An untight
door seal may lead to heavy frosting and thereby to a higher power
consumption (see also „What to do if...").

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply.
The supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electri-
cal installation must include suitable means of isolating the appliance
from the mains (e.g. fuse, cut-out, current trip or similar with a mini-
mum contact separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skil-
led electrician. Please contact your dealer or our customer service
department for repairs.
34
AC 220 ... 240 V 50 Hz or
220 ... 240 V~50 Hz