Related Manuals for JUNO JKI 1032
Summary of Contents for JUNO JKI 1032
- Page 1 JKI 1032 JKI 4032 JKI 1332 JKI 4332 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS MODE D’EMPLOI GEBRUIKSAANWIJZING 2222 146-32/1...
-
Page 2: Table Of Contents
Inner door reversal ......page Use ........page Operation . -
Page 3: Warnings
Repairs carried out by inexperienced persons may cause injury or more “ Frozen food must not be re-frozen once it has been serious malfunctioning. Refer to your local Service thawed out. Centre, and always insist on genuine spare parts. -
Page 4: Installation
Fig. 2 Push appliance into The appliance must be earthed. t h e h o u s i n g u n t i l The power supply cable plug is provided with a con- stop strip (A) touch- tact for this purpose. -
Page 5: Inner Door Reversal
Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. 10) and withdraw it from its seat together with the door; remove plug (2) and fit it in the hole left open on the opposite side; Fig. 10... -
Page 6: Use
Fig. 12 est temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow auto- matic defrosting and therefore reduced energy consumption. -
Page 7: Storage Of Frozen Food
Gradually pull the shelf in the direction of the arrows When first starting-up or after a period out of use, be- until it comes off, then reposition as required. fore putting the products in the compartment let the appliance run for at least two hours on the coldest Fig. -
Page 8: Defrosting
Fig. 16 ner liner, complete defrosting should be carried out as follows: pull out the plug from the wall socket or turn the ther- mostat knob to the «O» setting; remove any stored food, wrap it in several layers of newspaper and put it in a cool place;... -
Page 9: Maintenance
“ unhook the moving part by pressing it as shown in be carried out by authorized technicians. the figure. If the door is open and the light does not come on, Periodic cleaning check that the bulb is properly screwed in; if it still...
Need help?
Do you have a question about the JKI 1032 and is the answer not in the manual?
Questions and answers