Page 2
Explanations of the technical terminology used in the operating instructions can be found at the end in the section "Technical Terminology". The operating instructions contain instructions for the correction of possible malfunctions by the user in the section "What to do, if ...".
• If the a malfunction occurs on the appliance, is nevertheless flammable. please look first in the "What to do if ..." section of • During transportation and installation of the appli- these instructions. If the information given there...
This applies to your old • The appliance may not be disposed of with appliance, and - at the end of its service life - for your domestic waste or bulky refuse. new appliance as well.
The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature...
Electrical connection Before initial start-up, refer to the appliance serial If the socket is not accessible once the appliance is plate to ascertain if supply voltage and current values built in, the electrical installation must include suitable correspond with those of the mains at the installation means of isolating the appliance from the mains (e.g.
(see also "Defrosting" section). The result is the build up of a thick layer of frost on the fridge rear Note: From a food science point of view, wall.
Ensure that the bottle or cans do not touch the rear wall of the appliance or, when the door is closed, the door shelf. Always lay bottles in the shelf with the top to the front. Small bottles and cans can be placed crossways in the holder.
1. To change, lift the door storage compartment with the variable door storage compartment upwards and out of the holders in the door and remove the retaining bracket out of the guide under the door storage compartment.
Do not use defrosting sprays, they can be hazard- ous to your health and/or contain substances that 6. Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole with the aid of damage plastics.
What to do if ... Correcting Malfunctions A malfunction may be caused by only a minor fault Warning! Repairs to refrigerators/freezers that you can rectify yourself using the following may only be performed by qualified service instructions. Do not perform any other work on the engineers.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. Light bulb data: 220-240 V, max. 15 W, fitting: E 14 1. To switch off the appliance, turn the temperature regulator to position "0".
Aligning the furniture housing ... . 31 Install caps ......33 Rehingeing the door (where necessary) .
Page 16
The following installation steps are illustrated only when the door is hinged on the right. If you want the door hinged on the left, please carry out the following installation steps on the opposite side as appropriate.
Page 17
Push appliance into place and align Screw appliance into place Install caps Appliance door / furniture door connection a: Smooth furniture doors b: Furniture doors with frame and filling...
Need help?
Do you have a question about the JKI 4054 and is the answer not in the manual?
Questions and answers