Important Safety Instructions Technical specifications Installation Cleaning the interior Starting-up Positioning Temperatur control Electrical connection Fresh food refrigeration Door reversibility Inner arrangement Instructions for totally built-in appliances Defrosting Maintenance Periodic cleaning Periodic of non-operation Interior light Customer service and spare parts...
It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
Page 4
There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions. Parts which heat up should not be exposed.
Open the door and turn the thermostat control knob, Cooked foods, cold dishes, etc..: these should be to be found on the upper right hand side of the inner covered and may be placed on any shelf. compartment, clockwise beyond position «O» (OFF) Fruit and vegetables: these should be thoroughly to start the appliance.
Periods of non-operation D411 When the appliance is not in use for long periods, If the door is open and the light does not come on, take the following precautions: check that the bulb is properly screwed in; if it still remove the plug from the wall socket;...
Check that the defrosting water discharge hole is not obstructed. Technical specifications The technical data is indicated in the rating plate on the left side inside the appliance. Installation lf this appliance featuring magnetic door seals is to replace an older appliance having a spring lock...
Compatibility Directive) and subsequent modifications. Door reversibility The appliance’s door have been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. D163...
Page 9
(A). 4. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance.
Page 10
6. Apply covers (B) on joint cover lugs and into hinge holes. 7. Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes.
Need help?
Do you have a question about the JKI 3033 and is the answer not in the manual?
Questions and answers