Introduction; Qualified Persons; Read This Instruction Sheet; Retain This Instruction Sheet - S&C 2000 Series Installation & Operation Manual

Introduction

Qualified Persons

Read this
Instruction Sheet
Retain this
Instruction Sheet

Proper Application

Usual Operating
Conditions
2 S&C Instruction Sheet 716-504
Only qualified persons knowledgeable in the installation, operation, and maintenance
of overhead and underground electric distribution equipment, along with all
associated hazards, may install, operate, and maintain the equipment covered by this
publication . A qualified person is someone trained and competent in:
●
The skills and techniques necessary to distinguish exposed live parts from
nonlive parts of electrical equipment
●
The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
●
The proper use of special precautionary techniques, personal protective
equipment, insulated and shielding materials, and insulated tools for working on
or near exposed energized parts of electrical equipment
These instructions are intended only for such qualified persons . They are not intended
to be a substitute for adequate training and experience in safety procedures for this
type of equipment .
Thoroughly and carefully read this instruction sheet and all materials included in the
product's instruction handbook before installing or operating a Model 2020 Series
2000 Circuit-Switcher . Become familiar with the Safety Information on pages 4
through 6 and Safety Precautions on page 7 . The latest version of this
publication is available online in PDF format at sandc .com/en/contact-us/product-
literature/ .
This instruction sheet is a permanent part of a Model 2020 Series 2000 Circuit-Switcher.
Designate a location where users can easily retrieve and refer to this publication.
The equipment in this publication is only intended for a specific application . The
application must be within the ratings furnished for the equipment . Ratings for the
Model 2020 Series 2000 Circuit-Switcher are listed in the ratings table in Specification
Bulletin 716-31 . The ratings are also on the nameplate affixed to the product .
Series 2000 Circuit-Switchers will perform as intended at temperatures within the range
of –40°C to +40°C (-40°F to +104°F), at altitudes of up to 5000 feet (1524 m), and at wind
loadings of up to 90 miles (145 km) per hour. Further, Series 2000 Circuit-Switchers, when
installed with the recommended S&C anchor bolts and with flexible-conductor connec-
tions at all six terminal pads, are capable of withstanding seismic loading of 0.2 g ground
acceleration in any direction as well as performing as intended during such loading and
afterward. For applications at temperatures not within the specified range, at higher alti-
tudes, at higher wind loadings, or where higher seismic withstand capabilities are required,
refer to the nearest S&C Sales Office.
.
WARNING
NOTICE
WARNING