Installation Location; Electrical Connection; Door Reversibility - JUNO JCN 44141 Manual

INSTALLATION
Location
The appliance should be installed
well away from sources of heat such as
radiators, boilers, direct sunlight etc.

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
The a a ppliance m m ust b b e e e arthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to a
separate earth in compliance with
current regulations,
specialist technician.
The M M anufacturer
responsibility i i f
precautions a a re n n ot o o bserved.
This appliance complies with the
following E.E.C. Directives:
- 8 8 7/308 E E EC of 2/6/87 relative to radio
interference suppression.
- 7 7 3/23 E E EC of 19.2.73 (Low Voltage
Directive)
modifications;
- 8 8 9/336
(Electromagnetic
Directive)
modifications.
ATTENTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
consulting
d d eclines
t t he a a bove
and subsequent
E E EC of 3.5.89
Compatibility
and subsequent

Door reversibility

the r r ight d d oor o o pening. T T o c c hange
the o o pening d d irection o o f t t he d d oor
proceed a a s i i n t t he f f ollowing
instructions b b efore i i nstalling i i t.
1. Unscrew the upper pin and remove
the spacer
a
2. Remove the upper door
a a ll
3. Unscrew the middle hinge and the
s s afety
plugs and refit them on the opposite
side
4. Refit the upper door, the upper pin
and the spacer on the opposite
side.
The a a ppliance i i s s s upplied w w ith
electrolux 37