User Menu Screens - SmartVent Balance BAL225 User Manual

Operation and Monitoring

User Menu Screens

From the Normal Airflow screen, press the
Changing the value of a setting (if adjustable) is typically a 3-step procedure:
1.
Press
2.
Use the
for more than 2 seconds.
3.
Press
To return to the Normal Airflow screen, press the
5 seconds. Alternatively, the Normal Airflow screen will be restored if no buttons are pressed for two minutes
(timeout). Settings are stored in a the memory and will be retained in the event of mains power supply failure.
Low Airflow / Normal Airflow / Boost Airflow Screen
When the start-up screens are finished, the Low or
Normal screen is displayed showing operating status
(Low Airflow X % or Normal Airflow X % or Boost
Airflow X %).
The Normal screen displays the rate of normal airflow
(supply air) through the unit.
If the installation has proportional sensors or an internal
humidity sensor fitted, and any of these are boosting
the airflow, an α symbol will be displayed.
When the summer bypass is active, the normal screen
top line will alternate (for 3 seconds) with Summer
Bypass.
An interval can be set, (see page 39) of the Installation
Manual, at which the unit reminds the user to check
the filters. This will be 6, 12 or 18 months. The normal
screen top line will include Check Filter as a reminder
to check and, if necessary, clean or replace the filters.
When this has been done, press and hold the
buttons for 5 seconds to reset the automatic
message.
SmartVent Balance User Manual
to select the setting (the setting will flash).
or buttons to adjust the value. To scroll quickly, press and hold the
again to enter the new settings and move to the next screen.
button to access the rest of the User Menu screens.
button repeatedly or press and hold the
Normal Airflow
30 %
SUMMER BYPASS ON
30 %
Filter Service
Suburban
and
or buttons
button for
7