Summary of Contents for SystemAir fantech FADE Series
Page 1
FADE Series Wall Axial Fans PARTS IN THE BOX Wall Axial Fan FADE, 1 pc Operation and Installation Manual, 1 pc Systemair MFG Inc. certifies that the FADE Series shown herein is licensed to bear the AMCA Seal. The ratings shown are...
Page 2
Note Warning/ Information Technical Practical tip Important information note WARNINGS Read and Save these instructions for future reference. DO NOT CONNECT POWER SUPPLY until fan is completely installed. Make 1. FADE units can be mounted at any angle for exhaust ventilation. sure electrical service to the fan is in the locked “OFF”...
Page 3
DIMENSIONS FAD E S -T YP E FADE S-TYPE “Fan Only” Model “Fully Assembled” Model FAD E A -T YP E FADE A-TYPE “Fan Only” Model “Fully Assembled” Model Model Blade Type 12 5 / 16 10 1 / 4 7 3 / 4 8 1 / 16 1 / 4...
Page 4
WIRING SPECIAL WIRING PRECAUTIONS: All installation should be wired according to the following diagrams. Failure to comply will cause the motor to "hum" or not work. All units are pre-wired, just bring incoming supply into marked ports on terminal strip. (EXCEPT FOR 3 PHASE UNITS, please use a motor contactor &...
Page 5
WIRING (CONT'D) 460 Volt Three Phase Fans FADE 20-4, 22-6, 25-6 For 460 colt operation, Orange (W2), red (U2) and Grey (V2) wires must be spliced 1. Contactor should be used. Control coil should be wired in series with motor thermal contacts (TK leads) as shown in diagram to provide thermal motor protection 2.
WARRANTY Make a scan of the QR code above to access Fantech’s warranty in English, French, or Spanish. Includes a 5y warranty. If additional support is needed to retrieve the war- ranty, visit fantech.net; call (800) 747–1762 (US), (800) 565–3548 (Canada), or +52 55 1328–7328 (Latin America);...
Need help?
Do you have a question about the fantech FADE Series and is the answer not in the manual?
Questions and answers