Setting The Temperature; Changing The Temperature Unit; Led Light; Interior Equipment - Hanseatic HWC77FCIA User Manual

Setting the temperature

WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always ensure the prescribed ambi-
■
ent temperature is maintained (see
"Intended use" on page EN-4).
Select an internal temperature to suit the
wine. Further information on the optimum
storage temperature can be found in the sec-
tion "Maintaining quality" on page EN-16.
You can set the appliance to a temperature
from +5 °C to +22 °C (41 °F to 72 °F).
The temperature for the lower range can only
be set equal to or higher than the temperature
in the upper range.
1. Select the desired interior zone by press-
ing the key (9).
– once for the upper zone. The left-hand
temperature indicator (10) will flash.
– twice for the lower zone.
The right-hand temperature indicator (10)
will flash.
As long as the temperature indicator is
flashing, you can set the temperature.
2. The temperature of the selected zone can
be
– increased by pressing the
til the desired temperature is displayed.
– reduced by pressing the
the desired temperature is displayed.
After a short while the flashing will stop and
the desired temperature will be set.
The appliance will adjust itself to the set
temperature while showing the current in-
ternal temperature.
This increases the energy consumption.

Changing the temperature unit

You can choose whether the internal temper-
ature is displayed in Celsius or in Fahrenheit.
The small green symbol on the top right next
to the temperature indicator (10) lets you
identify the current setting.
• To change the unit, press the (13) key

LED light

• To switch the LED on or off, press the

Interior equipment

Removing the shelves
The bottle shelves (4) can be removed and
rearranged as necessary.
• Lift the rear of the bottle shelf slightly and
C
F
Inserting the shelves
key (11) un-
C
F
key (12) until
C
F
1. Turn the bottle shelf (4) so that the front
2. Insert the bottle shelf (4) into the side
Operation
If you set a lower temperature, you
will need higher cooling performance.
key (8).
C
pull it out.
(16)
rail (15) and back rail (14) are facing up
and the chamfered edges (16) are facing
forward.
brackets and slide it all the way back.
Page EN-13
.
C
F
F
(14)
(4)
(15)