Subscribe to Our Youtube Channel
Related Manuals for Vela Tango 600
Summary of Contents for Vela Tango 600
- Page 1 I N S T R U C T I O N F O R U S E VELA Tango 600 & 600ES VERSION: Manual. nr. 105671 VELA Tango 600 VELA Tango 600ES ISO 9001 ISO 14001 The chair’s design varies depending on the model...
- Page 2 CHAIR FUNCTIONS Backrest height Backrest angle Electric height adjustment Seat depth Manual height adjustment Brake Seat rotation (only 600S) Seat angle Tilt Armrest height Armrest width (handle on left side) Lenght:...
-
Page 3: Table Of Contents
TABLE OF CONTENTS 1.0. INTRODUCTION 1.1. WARNINGS 1.2. TROUBLESHOOTING 1.3. VELA TANGO WITH ELECTRIC HEIGHT ADJUSTMENT 1.3.1. Power input 1.3.2. Emission 1.3.3. Surge protection 1.4. LABELS USED ON THE CHAIR 1.5. SAFETY 1.5.1. Intended use 1.5.2. Transport 1.6. WARRANTY 1.7. UNPACKING THE CHAIR 1.8. -
Page 4: Introduction
1.0. INTRODUCTION DEAR CUSTOMER Congratulations on your new VELA chair! We are sure this chair will give you daily pleasure. This user manual provides useful information on adjusting, operating and maintaining your chair. Important Please read this user manual carefully and keep it safe for when you need to refer to it. -
Page 5: Warnings
1.1. WARNINGS In case of an allergic reaction, stop using the chair and consult a doctor Only use original spare parts from VELA Only use the supplied charger for charging the chair Do not make any changes to the accessories that come with the chair... -
Page 6: Troubleshooting
The backrest arm slides down Tighten the hand screw further, as shown in section 2.0.1. You can tighten the hand screw hard without damaging the product. If the above does not solve your problem, you should contact your VELA supplier. -
Page 7: Vela Tango With Electric Height Adjustment
Current: 0.5A Power: 12VA 1.3.2. EMISSION A VELA chair with electrical functions has been tested and complies with current requirements regarding electromagnetic radiation (EMC requirements). The chair is tested to the following specifications: :: Emission class CISPR 11, Group 1, Class B See more details at www.vela.eu... -
Page 8: Labels Used On The Chair
9200 Aalborg SV, Denmark. :: The chair is not built to stand on The VELA Tango with electrical func- :: The wheel brake must always be tions meets all safety requirements according to IEC 60601-1, including... -
Page 9: Transport
- 10°C. :: VELA chair 1.6. WARRANTY :: Instructions for use VELA grants a right of claim under applicable law in the country where :: Charger (only for chairs with elec- the chair is acquired. The right of trical functions) -
Page 10: Wheels
1.8.4. RECYCLING GUIDE Your VELA chair can be reused by another person when you no longer need it as long as the chair is serviced It is important that you return your by a technician beforehand. -
Page 11: Settings
2.0. SETTINGS The gas spring and the electric lifting mechanism should only be replaced by a VELA technician or a person trained in this field. 2.0.1. ATTACHING THE BACKREST Press the locking pin spring (1) and push the backrest arm through the hole. -
Page 12: Adjustment Of Seat Angle
Note: Setting the angle of backrest and seat should always be done with your feet flat on the floor. 2.0.5. ADJUSTMENT OF SEAT ANGLE Adjust the seat angle by pulling up the middle lever placed at your right hand. 2.0.6. ADJUSTMENT OF SEAT TILT* The entire seating unit moves (seat and backrest together) by lifting the middle handle on the right side. -
Page 13: Adjustment Of Back Height
2.0.9. ADJUSTMENT OF BACK HEIGHT Adjust by loosening the quick release handle on the backrest and regulate the height. Remember to tighten the quick release handle again. 2.0.10. BACK LATCH The backrest can be set to a specific angle by adjusting and secure the bolt which is mounted on the back of the chair back. -
Page 14: Footrest
2.0.14. ROTATION (MANUAL)* The seat is rotated by pulling the rear handle on the left side. VELA Note: Cannot be combined with Footrests, section: 2.0.13. TANGO 600S 2.0.15. -
Page 15: Setting The Angle Of The Brake
The hand box is used via push buttons on the front. TANGO VELA hand boxes can have one or more functions. The icons on the hand box show the button functions. Note: Insert plug in hand box to operate functions. -
Page 16: Electric Brake (Electric)
See a complete list of accessories at: www.vela.eu Note: Charger is included as an accessory when purchasing a VELA chair with electric functions. Depending on model www.vela.eu VELA :: Gøteborgvej 8-12 :: 9200 Aalborg SV :: Denmark :: Tel: +45 96 34 76 00 :: mail@vela.dk...
Need help?
Do you have a question about the Tango 600 and is the answer not in the manual?
Questions and answers