Yamaha AW4416 Manual Supplement page 8

AW4416 Version 2.0 Manual Supplement
MIDI Setup 2 page
In this page you can select the port that will be used
for MIDI transmission and reception: MIDI OUT/
THRU connectors, TO HOST connector, or option
slot. Here you can also select the synchronization
messages that will be transmitted to external devices.
Tip!
In this page, signal routes along which MIDI messages
flow are shown by a solid line ( | ), and signal routes
along which MIDI messages do not flow are shown by
a hollow line ( || ).
5
4
A
MIDI/HOST/OPTION switch
This selects the port that will be used to transmit/
receive MIDI messages. Move the cursor to this
area and press the [ENTER] key to cycle through
the following three settings.
• MIDI .......................The MIDI IN connector
• HOST ......................The TO HOST connector
• OPTION..................The OPTION I/O slot will
Tip!
The OPTION setting is valid only if an I/O card that
can transmit/receive MIDI messages (such as the
mLAN card "MY8-mLAN"; planned for availability in
the near future) is installed in option slot 2. MIDI
message transmission/reception cannot be per-
formed via option slot 1.
B
OUT/THRU switch
This switches the function of the OUT/THRU
connector. Move the cursor to this area and press
the [ENTER] key to cycle through the following
two settings.
8
3
1 2
and MIDI OUT/THRU
connector will be used.
will be used. The trans-
mission speed is set by
the TO HOST setting.
be used.
Version 2.0 Manual Supplement
• THRU......................The MIDI messages
received at the MIDI IN
connector will be retrans-
mitted from the OUT/
THRU connector.
• OUT........................Messages generated
within the AW4416 will
be transmitted from the
OUT/THRU connector.
C
TO HOST
Set the transmission speed of the TO HOST con-
nector according to the type of computer you are
using. Move the cursor to the TO HOST connector
graphic, and turn the [DATA/JOG] dial to select
the transmission speed from the following.
Setting Platform
PC1 NEC PC-9800/9821 series
IBM PC compatible, NEC
PC2
PC-9800/9821 series
MAC Apple Macintosh series
*1 Select PC1 or PC2 according to the driver you are
using.
*2 Only for models that provide a modem/printer
port. On the software you are using, set the clock
to "1 MHz."
D
MTC ON/OFF switch
This is an on/off switch for the MTC messages
that are sent to the MIDI OUT connector/TO
HOST connector/option slot.
E
MIDI CLK ON/OFF (MIDI Clock on/off)
switch
This is an on/off switch for the MIDI Clock mes-
sages that are sent to the MIDI OUT connector/
TO HOST connector/option slot.
Speed
*1
31.25 kbps
38.4 kbps
*1
*2
31.25 kbps