Yamaha AW4416 Manual Supplement page 14

AW4416 Version 2.0 Manual Supplement
You can also make settings so that a MIDI message
with a fixed value is transmitted only when the [ON]
key is turned on (lit). For example if you assign a pro-
gram change #1 message, the corresponding program
change message will be transmitted each time you
turn the [ON] key on.
Program change
number 1
Transmitted
ON ON ON
Using the MIDI Remote function
with the default settings
With the default settings, MIDI messages are already
assigned to some of the faders and [ON] keys. Here's
how to use the MIDI Remote function with the default
settings.
Tip!
For the MIDI messages that are assigned by default to
the faders/[ON] keys by the MIDI Remote function,
refer to page 35.
1
Connect the AW4416's MIDI OUT/THRU
connector to the MIDI IN connector of the
external device.
At this time, make sure that the MIDI Setup 2
page OUT/THRU switch is set to "OUT."
2
Press the [MIDI] key.
The MIDI screen will appear.
3
Hold down the [SHIFT] key and press the
[F1] key to switch tabs.
In the various pages of the MIDI screen, the
lower part of the display will show the tabs as
long as you hold down the [SHIFT] key, as shown
below.
14
Program change
number 1
Transmitted
ON ON
Version 2.0 Manual Supplement
In this state, you can press the [F1] key to access
the REMOTE screen.
The mixing layer that had been selected until
now will be cancelled, and a special mixing
layer called Remote A/Remote B will be in effect.
Remote A and Remote B are mixing layers that
let you use faders 1–16 and [ON] keys 1–16 to
transmit MIDI messages. Settings and operations
are performed in the following four pages.
Remote A 1-8
Assign MIDI messages to Remote A faders 1–8/
[ON] keys 1–8
Remote A 9-16
Assign MIDI messages to Remote A faders 9–16/
[ON] keys 9–16
Remote B 1-8
Assign MIDI messages to Remote B faders 1–8/
[ON] keys 1–8
Remote B 9-16
Assign MIDI messages to Remote B faders 9–16/
[ON] keys 9–16
4
Press one of the [F1]–[F4] keys to select the
mixing layer that you want to operate.
If you press the [F1]/[F2] keys, you will be able to
operate Remote A. If you press the [F3]/[F4] keys,
you will be able to operate Remote B. (In the
example screen shown above, the Remote A 1-8
page is selected.)
5
In the Remote A area in the right side of
the display, move the cursor to the DIS-
ABLE buttons for 1-8/9-16, and press the
[ENTER] key.
The button indication will change to "ENABLE,"
and the corresponding faders/[ON] keys can be
used for the MIDI Remote function.
If you set both the 1-8 and the 9-16 buttons to
"ENABLE," remote operations can be performed
using all faders 1–16/[ON] keys 1–16 of the
same mixing layer.