kingsley-bate CF30 Assembly Instructions

Download this manual

ASSEMBLY INSTRUCTIONS FOR THE CF30/31

TABLE TOP

STEP I:

Unpack, inspect, and lay the parts on a clean, flat, and soft surface to avoid damaging the

table components.

TABLE BASE

STEP II:

Lay the Table top upside down on a soft surface as shown below.

STEP IV:

Loosely thread all bolts to make sure the threads catch and then

tighten using the Allen Key provided. NOTE: DO NOT USE

POWER TOOLS AS IT MAY DAMAGE THE BOLT HEADS.

BOLTS & WASHERS

STEP III:

Place the Table base on top of the

inverted table top and align the holes.

Need help?

Do you have a question about the CF30 and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS FOR THE CF30/31 TABLE TOP TABLE BASE BOLTS & WASHERS STEP I: Unpack, inspect, and lay the parts on a clean, flat, and soft surface to avoid damaging the table components. STEP II: Lay the Table top upside down on a soft surface as shown below.
Page 2 STEP V: Adjust the threaded foot glides as needed. IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE. * KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY * 7200 Gateway Court, Manassas, Virginia 20109 Phone: (703) 361-7000, Fax: (703) 361-7001...

Cf31