Positioning - Russell Hobbs RHGCH601SS-B-M/01 Instruction Manual

Positioning

• This appliance is installed on the wall.
• Avoid damaging the product during installation
• The appliance can only be used safely if it is correctly installed
according to the safety instructions. The installer is responsible
for ensuring that the appliance works correct when installed.
• The width of the extractor hood must correspond at least with
the width of the hob.
• For the installation, observe the currently valid building
regulations and the regulations of the local electricity and gas
suppliers.
• When conveying the exhaust air, official and legal regulations
(e.g. state building regulations) must be followed.
• The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms that contain heating appliances. If
the exhaust air is to be conveyed into a non-functioning smoke
or exhaust gas flue, you must obtain the consent of the
heating engineer responsible.
• Always ensure adequate fresh air in the room if the appliance
is being operated in exhaust air mode at the same time as
room air-dependent heat-producing appliance is being
operated.
- 8 -