Russell Hobbs RHGCH601SS-B-M/01 Instruction Manual page 22

Cleaning and Maintenance:
3. Unclip the light module from its terminal
4. Remove the light module from its fitting in the panel (this may require
pressure or force to be applied).
5. Put the replacement light module into the fitting (ensuring the terminal is
threaded through the fitting) and connect it to the terminal.
6. Replace the panel by lifting it upwards and reinstall the 4 screws (a cross
headed screwdriver will be needed) and the grease filter. Then plug the
appliance back into the mains or switch on the circuit breaker in the fuse box.
Important note: If you cannot replace the light(s) in the above method you
can remove the hood from the wall as this will allow you to remove the
control panel completely by removing the 2 screws at the back of the unit.
- 22 -