Do you have a question about the WATER MACHINE and is the answer not in the manual?
Questions and answers
Julie
April 7, 2025
Inserted new filter, machine leaves, can't get filter out to start over.
1 comments:
Mr. Anderson
April 9, 2025
To remove a stuck filter from an UltraLux Water Machine, unscrew the filter from the top of the machine and lift it out. If it is stuck, ensure the machine is on the edge of a cupboard or in a position where you can easily access and apply enough force. Use caution and pull straight to avoid damage.
This answer is automatically generated
Shannon
April 6, 2025
After installing the machine and plugging it in, the initial automatic flush is taking longer than 30 seconds. It was still running at the 3 minute mark. I unplugged it.
There are no leaks.
1 comments:
Mr. Anderson
April 6, 2025
The initial automatic flush of the UltraLux WATER MACHINE should only take approximately 30 seconds. If it is taking longer than 3 minutes, the most likely cause is a problem such as low source water pressure, poor water quality, or a clogged filter, all of which can slow the flow rate and extend the flush time.
This answer is automatically generated
Peter Hale
April 10, 2025
do you change both filters at the same time
1 comments:
Mr. Anderson
April 10, 2025
No. The carbon composite filter (CBPA) should be replaced every 1 year or after 2000 gallons, while the RO membrane filter (ROCB) should be replaced every 2 years or after 1000 gallons.
This answer is automatically generated
Murli
April 23, 2025
When does the hydrogen light indicator comes on? During flush must the H indicator come on?
Need help?
Do you have a question about the WATER MACHINE and is the answer not in the manual?
Questions and answers
Inserted new filter, machine leaves, can't get filter out to start over.
To remove a stuck filter from an UltraLux Water Machine, unscrew the filter from the top of the machine and lift it out. If it is stuck, ensure the machine is on the edge of a cupboard or in a position where you can easily access and apply enough force. Use caution and pull straight to avoid damage.
This answer is automatically generated
After installing the machine and plugging it in, the initial automatic flush is taking longer than 30 seconds. It was still running at the 3 minute mark. I unplugged it. There are no leaks.
The initial automatic flush of the UltraLux WATER MACHINE should only take approximately 30 seconds. If it is taking longer than 3 minutes, the most likely cause is a problem such as low source water pressure, poor water quality, or a clogged filter, all of which can slow the flow rate and extend the flush time.
This answer is automatically generated
do you change both filters at the same time
No. The carbon composite filter (CBPA) should be replaced every 1 year or after 2000 gallons, while the RO membrane filter (ROCB) should be replaced every 2 years or after 1000 gallons.
This answer is automatically generated
When does the hydrogen light indicator comes on? During flush must the H indicator come on?