Table of Contents
Advertisement
MACHINE DISPLAY FUNCTIONS
On the UltraLux Water Machine front display, notice the illuminated
letters and buttons. Each have a specific function.
• RO Indicator: The white indicator light is "on"
when the Reverse Osmosis Filter is in use (when
dispensing UltraLux Water). It also indicates filter life.
- See page 15.
• CF Indicator: The white indicator light is "on" when
dispensing Filtered Water. It also indicates filter life
- See page 15.
• Select Button: Press the Select Button to highlight
which Filter to reset.
• Reset Button: Press and hold the Reset button
until the Machine chimes, to reset the selected
filter. Resetting the filter will restart the internal
calculator associated to that filter's life.
• Input TDS: This illuminated function indicates the
number of Total Dissolved Solids (TDS) of the
source water coming into the Machine.
• Output TDS: This illuminated function indicates the
TDS of the water being dispensed after passing
through the filters. This number should be above
0. This is integral for the electrolysis process to
create therapeutic levels of molecular hydrogen.
10
• Flush Button: Will flash after pressing the Flush
button to begin a 30-minute flush cycle of the Water
Machine. Utilize this feature after replacing a filter
or not using the Machine for an extended period of
time. This flushes the new filter and cleans the Water
Machine of any buildup.
• Hydrogen (H2) Indicator: This indicator will flash
when the UltraLux Water Machine is actively
producing hydrogen.
• UV Sanitation Indicator: The UV Sanitation
Indicator flashes when the UltraLux Water Machine
is producing UltraLux Water, indicating that the
UV-C light sanitation is active.
• Error Indicator: The Error Indicator will not
illuminate when the Water Machine is actively
running properly. When the indicator illuminates
white, this indicates that the Water Machine
needs to be unplugged from the power outlet
for 30 seconds and plugged back in. If it flashes
red, there is an internal error in the Machine.
- Please refer to page 19 for troubleshooting.
- Quick Links:
- Machine Display Functions
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WATER MACHINE and is the answer not in the manual?
Questions and answers
Inserted new filter, machine leaves, can't get filter out to start over.
To remove a stuck filter from an UltraLux Water Machine, unscrew the filter from the top of the machine and lift it out. If it is stuck, ensure the machine is on the edge of a cupboard or in a position where you can easily access and apply enough force. Use caution and pull straight to avoid damage.
This answer is automatically generated
After installing the machine and plugging it in, the initial automatic flush is taking longer than 30 seconds. It was still running at the 3 minute mark. I unplugged it. There are no leaks.
The initial automatic flush of the UltraLux WATER MACHINE should only take approximately 30 seconds. If it is taking longer than 3 minutes, the most likely cause is a problem such as low source water pressure, poor water quality, or a clogged filter, all of which can slow the flow rate and extend the flush time.
This answer is automatically generated
do you change both filters at the same time
No. The carbon composite filter (CBPA) should be replaced every 1 year or after 2000 gallons, while the RO membrane filter (ROCB) should be replaced every 2 years or after 1000 gallons.
This answer is automatically generated
When does the hydrogen light indicator comes on? During flush must the H indicator come on?
The hydrogen light indicator on the UltraLux Water Machine flashes when the machine is actively producing hydrogen. It should not activate during the flush cycle.
This answer is automatically generated