Download Print this page
Sealey SUPERSTART200D Quick Start Manual

Sealey SUPERSTART200D Quick Start Manual

12/24v 200a starter/60a automatic battery charger

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1.
SAFETY
1.1.
ELECTRICAL SAFETY
WARNING! It is the user's responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and all
9
electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products.
Electrical safety information. It is important that the following information is read and understood:
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
9
Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct fuse.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is replaced immediately by a
8
qualified electrician.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
9
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
9
a hazard.
The battery charger must only be plugged into an earthed socket-outlet
9
Ensure that repairs are carried out by a qualified electrician.
Children from age 8 years and above, persons with reduced physical, sensory, or mental capabilities those with lack of experience and
9
knowledge can use the appliance, if they have been given supervision or instruction concerning use of the appliance in a safe way to
understand the hazards involved.
Children shall NOT play with the appliance
8
Always operate battery charger in a well ventilated area.
9
NEVER smoke or allow a spark or flame in the vicinity of the battery or engine.
8
Cleaning and user maintenance on the appliance shall not be made by children without supervision.
8
The appliance shall be disconnected from its power source during service and when replacing parts and, if that the removal of the plug
9
is foreseen, it shall be clearly indicated that the removal of the plug has to be such that an operator can check from any of the points to
which he has access that the plug remains removed.
1.2.
GENERAL SAFETY
DANGER! BE AWARE, LEAD-ACID BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR
THIS REASON, IT VERY IMPORTANT TO READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY, EACH TIME YOU USE THE
CHARGING EQUIPMENT.
Follow these instructions and those published by the battery and vehicle manufacturers, and the maker of any equipment you intend to
9
use in the vicinity of the battery. Remember to review warning marks on all products and on engines.
WARNING! Modern vehicles contain extensive electronic systems.
You are required to check with the vehicle Manufacturer, for any specific instructions regarding the use of this type of equipment on
each vehicle.
No liability will be accepted for damage / injury, where this product is not used in accordance with all instructions.
9
1.3.
PERSONAL PRECAUTIONS
Ensure there is another person within hearing range of your voice and close enough to come to your aid, should a problem arise when
9
working near a lead-acid battery.
Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.
9
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
9
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean
9
running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current
9
which is high enough to weld a ring or the like to metal, which would cause severe burns.
Ensure hands, clothing (especially belts) are clear of fan blades and other moving or hot parts of engine, remove ties and contain long hair.
9
DO NOT smoke or allow a spark or flame in the vicinity of battery or engine.
8
WARNING! Wear complete eye protection and clothing protection, when working with lead-acid batteries.
Make sure someone is within range of your voice or close enough to come to your aid when you work with or near a lead-acid battery.
9
© Jack Sealey Limited
12/24V 200A STARTER/60A AUTOMATIC BATTERY
CHARGER
MODEL NO:
Warning:
Warning:
Corrosive
Explosive
substance
Material
Original Language Version
SUPERSTART200D
Wear
Warning:
Protective
Electricity
Gloves
Keep away
Use in
Protect
Well
from sources of
From
ignition:
Ventilated
Rain
Areas
Battery could
explode
SUPERSTART200D
Issue 2
24/04/24

Advertisement

loading
Need help?

Need help?

Do you have a question about the SUPERSTART200D and is the answer not in the manual?

Questions and answers

Summary of Contents for Sealey SUPERSTART200D

  • Page 1 SUPERSTART200D MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Specification

    IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN. Ensure the charger is in good order and condition before use. If in any doubt do not use the unit, contact your Sealey Dealer. Use the charger in the upright position only and ensure it is placed on a stable surface which will adequately support its weight.
  • Page 3: Operation

    5.2.4. Slide the backup rings onto both ends of the axle. Snap the small circlips onto the end of the axle on both sides. 5.2.5. Push the hubcaps into the center of the wheels. 5.2.6. Secure the foot stand using screws. OPERATION 6.1. DISPLAY PANEL FIG.4 Original Language Version SUPERSTART200D Issue 2 24/04/24 © Jack Sealey Limited...
  • Page 4 Press “START / STOP” button to start charging and the “Charge” light (STD / AGM / GEL). will turn orange. When the battery is fully charged, the “Full” light will turn green. Original Language Version SUPERSTART200D Issue 2 24/04/24 © Jack Sealey Limited...
  • Page 5: Maintenance

    7.1.1. Replace the blown fuses, put 2 fuses on the two poles on the back of the charger, and screw them securely. 7.2. Put the plastic cover on the fuses for protection. SUPERSTART200D Issue 2 24/04/24 © Jack Sealey Limited Original Language Version...
  • Page 6: Troubleshooting

    Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk...