Page 1
Dear Imesa customer! Welcome to the family of Imesa customers. We hope that you will have many years of use from your new machine. The machine has many features. To make the most of its functions, we recommend that you read the operating instructions before using the machine.
Contents Before using your machine for Washing the fi rst time Sort your laundry. Transport protection Turn on the main power switch Packing material Open the washer door and load Washer door the washing Language selection Add detergent and fabric softener, as required Checking water hardness Select the programme...
Page 3
Contents Troubleshooting The washer door will not open Opening the door in an emergency The machine will not start After power failure Wet washing still in the machine Error messages Over fl ow fault Information for test institute Energy labelling Technical data Transport protection Installation...
Before using your machine for the fi rst time Transport protection Checking water hardness Remove any transport protection devices before The quantity of detergent needed depends, installing the machine. See the "Transport amongst other things, on how hard the water protection"...
Safety instructions General • Children must be watched to ensure they do • Read the operating instructions and keep not play with the machine. them in a safe place. • The emergency door opening tool is • Installation of water and electricity, if attached to the rear of the detergent required, should be carried out by a qualifi...
Child safety Keep an eye on children! • Always close the washer door and start the programme immediately after you have added detergent. • Do not allow small children to use or play with the washing machine. • Store detergent and fabric softener out of the reach of children.
Description of the washing machine 1. Main power switch 2. Dispenser 3. Programme panel 4. Serial number plate (on inside of washer door) 5. Drainage pump cover 6. Drainage pump (behind cover) 7. Washer door...
Dispenser 1. Pre-wash 2. Main wash with liquid detergent. Use the separator (A). 3. Main wash with powder detergent. Do not use the separator. 4. Fabric softener 5. Release button 6. Child safety catch...
Advice and tips before washing Here are some tips that may help you before If you do not do so, there is a risk that the colour washing. will run. Use detergent without bleach in order to preserve the colour of the fabric. Sorting your laundry Unbleached linen Sort items according to:...
Washing Sort your laundry. Wash ball or net See the "Advice and tips before washing" If you use a wash ball or net, place it directly in chapter. the drum and select a programme without pre- Place underwired bras in a laundry net. wash.
Washing Select the programme Programme selector Time remaining Start Main power switch Program Stop The display shows the programme name, the Super quick wash, 60 °C water temperature and the spin speed. Fast programme for laundry that just needs The washing machine has a number of freshening up.
Page 12
Washing Programme chart Water consumption (approx.liter) Program Cold Standard cotton, 60 °C 1200 1,20 3:05 Standard cotton, 40 °C 1200 0,70 2:55 Heavy wash, 90 °C 1200 2,35 1:35 Heavy wash, 60 °C 1200 1,15 1:15 White, 90 °C 1200 1,35 0:58 White/Colour, 60 °C...
Washing Close the washer door and Once the program has fi nished press the Start button The text "Done" is shown on the display for 10 minutes. The machine then turns off . NOTE! Once the program is fi nished, the washer door will automatically unlock.
Settings You can change the following Temperature settings: 1. Turn the programme selector to choose • Language between: °C and °F. • Temperature °C/°F 2. Press the Stop button once to save the • Water intake setting. • Child-safe Water intake Do as follows to open the settings menu: Connecting to both the hot and cold water 1.
Care and cleaning Cleaning the trap and the drainage Cleaning the detergent compartment pump Pull out the detergent compartment using the The washing machine has a trap where smaller release button. objects such as coins and hairpins can collect. To clean the trap and the drainage pump, do as follows: 1.
Care and cleaning Cleaning the inside of the machine to 3. Lift the agitator. avoid unpleasant smells 4. Remove any objects. Modern detergents often allow clothes to be 5. Place the agitator in the mounting hole with washed at low temperatures. This means that the F-mark towards you.
Troubleshooting The washer door will not open D Push the tool downwards to open the • Check that the main power switch is on. washing machine door. • Has the power supply been cut off ? Check the house fuses (circuit breakers). Opening the door in an emergency WARNING! The door may only be opened manually if...
Troubleshooting Error messages Water inlet fault If an error occurs during the programme a Check: message is shown on the display. To exit • that the tap on the water pipe is open. the message after taking measures, turn the •...
Technical information Information for test institute Energy labelling European test standard: EN 60456 Washing program: Standard cotton, 60 °C, 1200 rpm, 8 kg cotton Connection: Cold water 15 °C Test method for noise measurement: IEC-60704-2-4 Technical data Height: 850 mm Width: 595 mm Depth:...
Transport protection Remove the three transport bolts and the plastic 3. Remove the plastic covers from the plugs. plugs for locking the machine for transport Push the plastic covers into the three holes before using the machine. that contained the plugs. Save the plastic plugs in case the machine is moved in the future.
Installation Positioning the washing machine The washing machine can be installed as a built-in or freestanding unit. Place the machine on a fi rm surface with easy access to the plug. A. Built-in The washing machine can be installed under a counter top with a working height of 850-900 mm.
Installation Drainage connection Electrical installation The machine is supplied with a drainage hose If the machine is delivered from the factory attached, which must be connected to a drain. with a plug attached, it can be connected to an See the examples below. The height must be earthed wall socket.
Service Before contacting the service division Model Before you contact the service division, make designation sure that you know the model designation, type designation and serial number. The model designation can be found on the panel. The type designation and serial number Type plate can be found on the type plate on the inside of the washer door.
You select a programme by turning the programme selector. The selected programme is shown in the display. CLOSE THE WASHER DOOR AND PRESS THE START BUTTON The time remaining is shown in hours and minutes. We reserve the right to make changes. WM70.C LM7PEDP IMS en (03-15)
Need help?
Do you have a question about the LM7PEDP and is the answer not in the manual?
Questions and answers