Sunny SG-IP66 Series User Manual

USER MANUAL
Self-Contained Emergency Light SG-IP66 Series
Installation and Operation
1. The unit can be installed on leveled ground or hung up.
2. Install properly and securely to prevent accidents that could cause damage to the unit or
other people and property.
3. Plug the unit into a power socket with a 220-240VAC power supply. The emergency lamp will
remain on for about 2 seconds before turning off, Notice the LED will show the status as follows.
3.1 The LED "AC" will turn on indicating that the unit is receiving power.
3.2 LED "On/Test" lit or flashing slowly indicates the status of the unit ready to use.
3.3 The LED "Charge/Fail" will be on when the battery is charging.
3.4 The LED "Charge/Fail" will be off when the battery is fully charged.
4. When the unit is operational, tests can be performed.
4.1 Pressing the "5 secs" switch the emergency lamp will remain on for about 5 seconds before
turning off.
4.2 Unplug the unit from the 220-240VAC socket and the emergency light should turn on
automatically and plugging the unit back in should cause the emergency lamp will remain on for
about 5 seconds.
5. During power outages the emergency light should automatically turn on and will turn off
automatically and start charging the battery once power is restored.
Caution: Please always read the manual prior to installation and operation.
LED AC
Indicates that the unit is receiving a power supply
LED On/Test
Indicates that the unit is receiving a power /
Indicates that the unit is set to perform automatic self-tests /
Indicates if the unit is performing a self-test
LED Charge/Fail
Indicates that the unit's battery is charging
or is a problem with the battery
IR
Infrared signal receiver
Status Indicators
1