Sunny CU Series User Manual

USER MANUAL
Self-Contained Emergency Light CU-NC Series
Features
1. Controlled by a highly intelligent 8-bit micro controller.
2. Automatically self-test every 30 days and 90 days to help extend the life of the
battery.
3. Testing can be activated remotely using the infrared remote.
4. A quick test function on the unit that can carry out a self-test in 5 seconds.
5. The time and date of the automatic test can be set from both the remote and the
unit itself.
6. Using high quality LEDs with a lifetime of over 50,000 hours, providing bright and
constant illimitation throughout its operation.
7. The unit's outer case is made from ABS UL94 V-O Flame Retardant plastic that is
highly resistant to impact and corrosion.
LED AC Indicate that the unit is receiving power.
LED Charge/Full Gives information on battery charging.
LED Battery Indicate battery voltage range
LED Fail Indicate error status.
LED 5 sec Indicate the unit is performing a 5 second test.
LED 30 mins Indicate the unit is performing a 30-minute test.
LED 60 mins
Indicate the unit is performing a 60-minute test.
Switch ON/OFF Press to turn ON/OFF the lamp. (while the unit is not plugged in)
Switch Test For testing the device's availability. (during normal circumstance)
IR Receiver Infrared signal sensor used to receive signal from
the infrared remote.
Dimmer Press to adjust the brightness level
(only supported in the HZ models).
Status Indicators and Testing Buttons
5 30 60
secs mins mins
Remote Testing