Setting The Sleep Timer - Aiwa NSX-V2100 Operating Instructions Manual

About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
To erase a recording
A previous recording is erased when a new recording is made
on that part of that tape.
1
Insert the tape you want to erase into deck 1.
2 Press the TAPE button.
3 Wind up the tape to the point where the erasure is to be
started.
4 Press lhe button on deck 1 to start erasure.
COPYRIGHT
Please check the laws on copyright relating to recordings from
discs, ri~dio or external tape for the country in which the
machine is being used.
SETTING THE SLEEIP TIMER
1
2
The unit can be turned off automatically at a specified time.
Use the remote control.
1
Press the SLEEP button while pressing the SHIFT
button.
2 Within 4 seconds, press the +< or b> button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that "SLEEP on the display disappears.
ENGLISH
12