Page 1
With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE! Mit Ihrer inspirierenden Bewertung wird COSTWAY konsistenter sein, um Ihnen EIN SCHÖNES EINKAUFSERLEBNIS, GUTE PRODUKTE und EFFIZIENTEN SERVICE zu bieten! Avec votre évaluation inspirante, COSTWAY continuera à...
Page 2
DANGER ANS Z21.97 CSA 2.41-2017 Outdoor Decorative Gas Appliances INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference CARBON MONOXIDE HAZARD DANGER FIRE OR EXPLOSION HAZARD This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you.
DO NOT burn solid fuels in this appliance. IMPORTANT SAFETY INFORMATION This outdoor gas appliance is for Outdoor Use ONLY. This outdoor gas appliance is not intended to be installed in or The installation must conform with local codes or, in the absence on recreational vehicles and/or boats.
IMPORTANT SAFETY INFORMATION ABOUT PROPANE GAS The propane supply cylinder to be used must be constructed and marked in accordance with the U.S. Deparment of Transportation (D.O.T.) Specifications for propane cylinders, or the Standard for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as applicable.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY Table top assembly 1 pc Front panel 1 pc Door panel 1 pc Back panel 1 pc Right panel 1 pc Front-right leg 1 pc Front-left leg 1 pc Back-left leg 1 pc Back-right leg 1 pc Gas cylinder support 1 pc...
Page 6
3. Attach front panel (B) to front-left leg (G) and front-right leg (F) ASSEMBLY INSTRUCTIONS with bolts (AA) and washer (CC) using hex screw driver (DD), (see Figure 3). 1. Carefully unpack all parts from the box, compare parts with NOTE: DO NOT tighten the screws completely.
Page 7
5. Attach back panel (D) to back-left leg (H) and back-right leg (I) 7. With the help of another person, carefully turn the fire pit to the with bolts (AA) and washer (CC) using hex screw driver (DD), upright position. Attach the door panel (C) to the back-left leg (H) (see Figure 5).
Page 8
9. Open the box of lava rocks, put the lava rocks (K) into the fire bowl of the fire table, (see Figure 9). A gas fire pit requires 13.2 lbs lava rocks. WARNING: Keep children away during assembly, as this item contains lava rock, which are small pieces and can be swallowed by children.
Page 9
10. Open the door panel (C). Place the gas cylinder into the gas 11. Cover the re pit with the outdoor weather cover (L) when cylinder support (J) and connect the regulator by turning the black not in use to protect it from the elements or when re pit is cool handle clockwise to tighten.
3. Replace the propane orifice with the natural gas orifice and screw STOP STOP the natural gas orifice to the bellows tightly. NATURAL GAS CONVERSION Then connect and tighten the natural gas orifice to the inlet tube (see Figure 14). The Natural gas orifice (4.18 mm diameter size ) is Natural gas conversion must be performed only by natural gas painted with a black mark.
Page 11
4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta cs.us@costway.com volverá a su posición hacia afuera. Espere 5 minutos antes de intentar encender el quemador nuevamente, repita los pasos 1 al 3.
Page 12
LEAK TEST To prevent fire or explosion hazard when testing for a leak: 1. Always perform the leak test as described below before lighting this appliance or each time the cylinder is connected for use. 2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
Observe Flame Height When Lit: The burner will display blue and LIGHTING INSTRUCTIONS yellow flames. These flames should be a blue / yellow color between 1~2 in. height, (see Figure 25). These flames should not be yellow 1. Push in gas control knob slightly and turn to “OFF”. or produce thick smoke.
REPLACEMENT PARTS LIST CARE AND MAINTENANCE To enjoy the outstanding performance from your fire pit, make sure PART# DESCRIPTION you perform the following activities on a regular basis: Table top assembly 1. Use warm soapy water for cleaning. Never use flammable or F210103-TTA corrosive cleaning agents.
Need help?
Do you have a question about the NP10464US and is the answer not in the manual?
Questions and answers