Page 1
With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE! Mit Ihrer inspirierenden Bewertung wird COSTWAY konsistenter sein, um Ihnen EIN SCHÖNES EINKAUFSERLEBNIS, GUTE PRODUKTE und EFFIZIENTEN SERVICE zu bieten! Avec votre évaluation inspirante, COSTWAY continuera à...
Page 2
DANGER ANS Z21.97 CSA 2.41-2017 Outdoor Decorative Gas Appliances INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference CARBON MONOXIDE HAZARD DANGER This appliance can produce carbon monoxide which has no odor. FIRE OR EXPLOSION HAZARD Using it in an enclosed space can kill you.
Page 3
DO NOT burn solid fuels in this appliance. IMPORTANT SAFETY INFORMATION This outdoor gas appliance is for Outdoor Use ONLY. This outdoor gas appliance is not intended to be installed in or on The installation must conform with local codes or, in the absence recreational vehicles and/or boats.
Page 4
IMPORTANT SAFETY INFORMATION ABOUT PROPANE GAS This appliance is certified by CSA (Canadian Standards The propane supply cylinder to be used must be constructed Association) to ANS Z21.97 ● CSA 2.41-2017, Outdoor and marked in accordance with the U.S. Deparment of Decorative Gas Appliances.
Page 5
PACKAGE CONTENTS ASSEMBLY INSTRUCTIONS 1. Carefully unpack all parts from the box, compare parts with package content listed above, make sure all parts are present before beginning assembly of product. If any part is missing or damaged, do not attempt to assemble the product. 2.
Page 6
4. Attach the door (C) with fire table (B) tenderly (See Figure 4). pilot box Figure 2 Figure 4 5. Once the firepit has cooled completely after use, carefully place 3. Open the door. Place the gas cylinder into the gas cylinder the lid (A) onto the fire bowl and use the weather cover (D) to support and connect the regulator by turning the black handle protect your fire pit from the elements (See Figure 5).
Page 7
3. Replace the propane orifice with the natural gas orifice and screw STOP STOP the natural gas orifice to the bellows tightly. NATURAL GAS CONVERSION Then connect and tighten the natural gas orifice to the inlet tube (see Figure 8). The Natural gas orifice (4.18 mm diameter size ) is Natural gas conversion must be performed only by qualified painted with a black mark.
Page 8
If part missing or damaged, or you need help with assembly, please do not hesitate to contact our customer service email us at tent, car or home. cs.us@costway.com 4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta volverá...
Page 9
LEAK TEST To prevent fire or explosion hazard when testing for a leak: 1. Always perform the leak test as described below before lighting this appliance or each time the cylinder is connected for use. 2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
Page 10
Good LIGHTING INSTRUCTIONS Yellow 1. Push in gas control knob slightly and turn to “OFF”. 2. Turn gas control knob to “ON/MIN”. Yellow 3. Push in gas control knob all the way and hold. Continue to press Light Blue the ignition button for 15 seconds. 4.
Need help?
Do you have a question about the NP10632WL-BN and is the answer not in the manual?
Questions and answers