Page 1
With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE! Mit Ihrer inspirierenden Bewertung wird COSTWAY konsistenter sein, um Ihnen EIN SCHÖNES EINKAUFSERLEBNIS, GUTE PRODUKTE und EFFIZIENTEN SERVICE zu bieten! Avec votre évaluation inspirante, COSTWAY continuera à...
INSTALLER: Leave this manual with WARNING: the appliance. For Outdoor Use Only. Installation and service CONSUMER: Retain this manual for must be performed by a future reference. ANS Z21.97 CSA 2.41-2017 qualified installer service Outdoor Decorative Gas Appliances DANGER agency, or the gas supplier. FIRE OR EXPLOSION HAZARD If you smell gas: WARNING...
Page 3
6. Clothing or other flammable materials should not be hung from 16. Before each use of this gas appliance, inspect the burner. The the appliance or placed on or near the appliance. burner must be replaced prior to the appliance being put into operation if it is evident that the burner is damaged.
10. Cylinders must be stored outdoors in a well-ventilated area out of IMPORTANT SAFETY INFORMATION ABOUT the reach of children. Disconnected cylinders must have threaded PROPANE GAS valve plugs tightly installed and must not be stored in a building, garage or anyother enclosed areas. 1.
WARNING: keep children away during assembly, as this item PACKAGE CONTENTS contains lava rock, which are small pieces and can be swallowed by children. NOTE: leave the pilot box uncovered by the lava rock. CAUTION: Please be advised that this fire pit is equipped with natural lava rock that may crackle or pop the first time it is used.
Page 6
4. Attach the door (B) with fire table (A) tenderly, (See Figure 4). pilot box Figure 2 3. Place the gas cylinder into the gas cylinder support and connect the regulator by turning the black handle clockwise to tighten. To Figure 4 remove the regulator, turn the black handle counter-clock wise.
Page 7
BATTERY LEAK TEST Make sure the control knob is in the “OFF” position. Unscrew the push To prevent fire or explosion hazard when testing for a leak: button cap on the ignitor module located on the control panel to 1. Always perform the leak test as described below before lighting access the battery compartment.
LIGHTING INSTRUCTIONS 1. Push in gas control knob slightly and turn to “OFF”. 2. Turn gas control knob to “ON/MIN”. 3. Push in gas control knob all the way and hold. Continue to press the ignition button for 15 seconds. 4.
Observe Flame Height When Lit: The burner will display blue and 3. Air flow must be unobstructed. Keep controls, burner, and yellow flames. These flames should be a blue / yellow color between circulating air passageways clean. Signs of possible blockage 1~2 in.
Need help?
Do you have a question about the NP10422 and is the answer not in the manual?
Questions and answers