Harbor Freight Tools ICON 57996 Owner's Manual & Safety Instructions page 3

15. Do not allow any lubricants to make contact between
any part of the Press Set and the part being pressed.
Lubricants of any type on the above mentioned parts
will diminish the ability of the Press Set to firmly
and safely grip and hold the Press Set in position.
16. Examine the Press Set for structural cracks,
bends, and any other condition that may affect
the safe operation of the tool. Do not use the
Press Set even if minor damage appears.
Press Frame Assembly
1. Insert Sleeve Adapter (22) through hole of
Press Frame (10).
2. Use pliers (sold separately) to attach Snap Ring (18)
to end of Sleeve Adapter. Place Snap Ring in the
groove of the Adapter - securing the Adapter to the
Press Frame.
Snap
Ring (18)
Item 57996
SAVE THESE INSTRUCTIONS.
Sleeve
Adapter (22)
Press Frame Assembly
For technical questions, please call 1-888-866-5797.
17. Read and understand all instructions and safety
precautions as outlined in the manufacturer's manual
for the vehicle you are servicing. Use the vehicle
manufacturer's recommended ball joint press points.
18. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
Note: The Pressure Screw (15) is screwed into the
Press Frame at the factory.
Press Frame (10)
Page 3