Haier DWL 2825 D00 User Manual page 23

HEATED DRY
Select this option to dry dishes with heat.
3
Not selecting heated dry skips the drying period. If the heated drying period is
not selected the dishes take longer to dry and some spotting can occur. For best
drying, always use a liquid rinse aid. Some items (such as plastics) may need
towel drying.
NOTE: Heated Dry is an option with Pots and Pans Wash, Normal and China/
Crystal cycles. For faster air drying, you can open the door a couple of
inches after the final rinse is complete.
STEAm OPTION
Use for all dish loads, including extra large loads. Steam is generated early in
the cycle to help wet baked on soils from dish load and soften it for easier remov-
al by the wash system. The steam cycle raises the temperature in the final rinse to
150ºF (66ºC).
NOTE: This option can be used with all cycles except Rinse and Hold and Speed
cycle.
DELAY HOURS (select models)
Select this option to run your dishwasher at a later time or during off-peak hours.
You can add items to the load anytime during the delay countdown. After adding
items, close the door firmly until it latches.
You can delay the start of a cycle up to 9 hours in 3 hour increments (3, 6, or 9 Hr)
To delay the start
1. Open the door
2. Repeatedly press "Delay Hours until you see the desired hours of delay lighted
in LED indicator on the left. When the delay reaches 9 hours, the delay turns
off. Press "Delay Hours" again to select a new number of delay hours.
1
3. Select a wash cycle and options
3
4. Close the door
NOTE: To cancel the delay and cycle, press Cancel. To Cancel the delay and
start the cycle immediately, press Delay Start until there is no light in any
of LED indicators on the left.
PANTONE COOL GRAY 9C
GENERAL TOLERANCESP
QUALITY
(UNLESS SPECIFIED)
SYMBOLS
4 PLACES
0
=
3 PLACES
C
0 2 PLACES
=
1 PLACE
ANGULAR
DRAFT WHERE APPLICABLEP
MUST REMAINP
WITHIN DIMENSIONS
2
PANTONE 1805C
mm
INCH
DRAWN BY
Michael
CHECKED BY
+0.25
+0.75
APPROVED BY
+0.1
MATERIAL NO.
SIZE
A2
DIMENSION STYLE
mm
DATE
2009/07/06
DATE
DATE
SEE NOTES
THIS DRAWING CONTAINS INFORMATION THAT IS PR
INCORPORATED AND SHOULD NOT BE USED WITHOU
2
1
SCALE DESIGN UNITS
1:1 mm
TITLE
GRAPHIC O
MOLEX INC
molex
DOCUMENT NO.
E-160XX-101
22