D-Link DSL-300T User Manual page 33

4. Leave the default QoS values if you are unsure or the ISP did not provide this information.
5. Do not change the PCR or SCR values unless you are required to do so. If you are told to change these, type
in the values given to you by your service provider.
6. The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating the
PPP packet. Contact your ISP to make sure which encapsulation is being supported.
7. Click the Apply button when you have entered all the information. The browser window may briefly go
blank. After a few seconds the new connection you just configured will become the active connection for the
Modem.
8. To make your temporarily saved connection permanent, click the Save All button in the System
Commands window on the Tools tab.
Static IP
Static is used whenever a known static IP is assigned. The accompanying information such as the Subnet mask
and the gateway should also be specified in order to be able to connect. Up to three Domain Name Server (DNS)
addresses can also be specified. These are the servers would enable you to have access to other web servers.
Valid IP addresses range from 0.0.0.0 to 255.255.255.255.
To configure the WAN connection for Static, perform the steps listed below. Some of the settings do not need to
be changed the first time the device is set up, but can be changed later if you choose.
1. Click the Connection 1 button under WAN Setup to view the default PPPoA Connection Setup
configuration menu.
DSL-300T ADSL Modem User's Guide
Figure 3- 7. Setup Static IP
23