Connection Of The Water Pipe To The Cold Water Mains Line - Beko GNE 45730 Manual

Connection of the Water Pipe to the Cold Water Mains Line

1. Separate the nut from the tap adaptor. (Figure
A)
2. As shown in the figure, assemble the tap
adaptor to 1/2" valve fitting (Figure B)
3. As shown in the figure, after inserting the water
pipe to the nut, install it to the tap adaptor and
insert to the tap as shown in the figure. (Figure C)
4. Tighten the nut manually. In case of a leak use a
spanner or a pair of pliers to tighten the nut.
Caution: Secure the water pipe to suitable
Tap Adaptor
Main Cold Water Line
Feed Valve
Mesh Filter
Nut
Figure A
Tap Adaptor
Figure B
points by means of the pipe clips supplied to
avoid any damage or displacement or accidental
disconnection.
Caution: After turning on the water valve, make
sure that there is no leakage at both connection
points of the water pipe. In case of a leak, turn off
the valve immediately and tighten all joints again
using a spanner or a pair of pliers.
EN
11
Tap Adaptor
Nut
Water Tube
Figure C