Installation Requirements - Beko GNE 45730 Manual

Installation Requirements

In order to operate the automatic ice maker/
dispenser and chilled water dispenser, your
appliance needs to be plumbed into the cold
mains water supply in your house via a standard
1/2 " valve fitting. In case this valve is not present
or in case you are not sure, consult a qualified
plumber.
* First of all, make sure that the parts on the side
are shipped with the device.
1. 5-meter long water pipe (1/4 inch in diameter)
2. Cold mains water valve with mesh filter (Tap
Adapter)
3. 3 pieces of pipe clips (In case required to
secure the water pipe)
4. Water Filter to be fitted to the bracket inside
the fridge compartment.
5. Nut for connection of the water pipe to the
rear of the appliance
1
4
2
3
5
10
Connection to the Cold Mains
Please follow the instructions below.
MAKE SURE THAT STANDARD 1/2" VALVE
FITTING FED BY COLD MAINS WATER
SUPPLY IS AVAILABLE AND IS TURNED OFF
FULLY.
Connection of the Water Pipe to the
Refrigerator
1. After assembling the nut on the water pipe,
insert the water pipe to the refrigerator inlet valve
by pressing downwards firmly.
2. Fix nut as seen in the opposite figure, by
squeezing by hand on the refrigerator inlet valve.
Note: You should not need to tighten the nut with
a tool to achieve water tight assembly. In case of
a leak use a spanner or a pair of pliers to tighten
the nut.
EN
Water Tube
Water Tube
Nut
2
1
Valve