Setting The Speaker Impedance; Turning On And Off The Power - Yamaha HTR-6150 Owner's Manual

Setting the speaker impedance

Caution
If you are to use 6 ohm speakers, set "SP IMP." to
"6Ω MIN" as follows BEFORE using this unit.
Press C SYSTEM OFF on the front panel to
1
set this unit to the standby mode.
Refer to the right column for details.
Press and hold N TONE CONTROL and
2
then press A MAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
down
TONE CONTROL
Press O PROGRAM l / h to select "SP
3
IMP.".
"SP IMP." and the current speaker impedance setting
("8Ω MIN") appear in the front panel display.
Press P STRAIGHT repeatedly to select "6Ω
4
MIN".
Press A MAIN ZONE ON/OFF to save the
5
new setting and turn off this unit.
Note
The setting you made is reflected next time you turn on this unit.

Turning on and off the power

■ Turning on this unit
Press A MAIN ZONE ON/OFF (or H POWER)
to turn on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press A MAIN ZONE ON/OFF (or
I STANDBY) to set this unit to the standby
mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
MAIN ZONE
y
ON/OFF
You can set the main zone and zone 2 to the standby mode
simultaneously by pressing CSYSTEM OFF.
Connections
23
En