Selecting The Night Listening Mode - Yamaha HTR-6050 Owner's Manual

■ Selecting the night listening mode

The night listening modes are designed to improve
listenability at lower volumes or at night.
Press D AMP and then press L NIGHT
1
repeatedly to select "NIGHT:CINEMA" or
"NIGHT:MUSIC".
Choices: NIGHT:CINEMA, NIGHT:MUSIC, OFF
• Select "NIGHT:CINEMA" to reduce the dynamic
range of film soundtracks and make dialog easier to
hear at lower volumes.
• Select "NIGHT:MUSIC" to preserve ease-of-
listening for all sounds.
• Select "OFF" if you do not want to use this feature.
y
When a night listening mode is selected, the NIGHT
indicator lights up in the front panel display.
2
Press G l / h to adjust the effect level while
"NIGHT:CINEMA" or "NIGHT:MUSIC" is
displayed in the front panel display.
Choices: MIN, MID, MAX
• Select "MIN" for minimum compression.
• Select "MID" for standard compression.
• Select "MAX" for maximum compression.
y
"NIGHT:CINEMA" and "NIGHT:MUSIC" adjustments are
stored independently.
Notes
• You cannot use the night listening modes in the following cases:
– when the DIRECT STEREO mode (see page 34) is selected.
– when the component connected to the MULTI CH INPUT
jacks is selected as the input source.
– when headphones are connected to the PHONES jack.
– when the sound field program is selected while you enjoy
music contents in a USB memory device etc.
• The night listening modes may vary in effectiveness depending
on the input source and surround sound settings you use.
■ Displaying signal information
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
Press D AMP and then press Q MENU on
1
the remote control.
The top "SET MENU" display appears in the OSD.
SET MENU
TOP MENU
. ;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
2
Press G n repeatedly to select "SIGNAL
INFO" and then press G ENTER.
The following information about the input source
appears in the OSD.
;SIGNAL INFO
. FORMAT
SAMPLING
CHANNEL
BITRATE
FLAG
[RETURN]:Exit
Display
FORMAT
Signal format.
The number of samples per second taken
SAMPLING
from a continuous signal to make a
discrete signal.
The number of source channels in the
CHANNEL
input signal (front/surround/LFE).
The number of bits passing a given point
BITRATE
per second.
Flag data encoded in DTS, Dolby Digital,
FLAG
or PCM signals that cue this unit to
automatically switch decoders.
y
The information indicated by the cursor is also displayed in
the front panel display.
Press Q MENU again to exit from "SET
3
MENU".
Playback
DolbyD
48kHz
3/2/0.1
384kbps
None
Description
35
En