D-Link SecuriCam DCS-5300 User Manual page 67

Using IP surveillance Software (continued)
Check here to enable proxy.
Set the proxy
Check here to enable filter
Enter IP address to add
Add an IP address
Delete an IP address
If you enable proxy server and enable IP restriction, the listed IP
addresses will not use the proxy.
Connecting to the DCS-5300
Once you connect to the DCS-5300, you can drag and drop a camera into the
video area.
In the channel area, if you do not set up the camera, the color of the camera
number will be gray. Once you set up the camera, the color of the camera
number will turn to blue. You can drag and drop the camera into the video
area, and apply other features if you have the privileges by logging on as an
administrator (admin).
There is a unique light signal above each camera's number. This indicates the
status of the camera:
–
Off
–
Green
–
Red
–
Blink
Click OK
Camera is not connected.
The green light means the camera is connected.
The red light indicates the camera is both connected and in
recording mode.
If motion detection is enabled, an alert occurs and the light will
blink.
67