Anycubic Kobra 3 Combo FAQ EN
How long does the entire installation process take for the
machine?
The machine installation generally takes about 15 minutes to assemble, but there may be differences
depending on individual manual skills.
How much time does each of the machine's functions such as
vibration detection, PID calibration, and automatic leveling take?
Vibration detection takes about 4 minutes, PID calibration takes about 6 minutes, and automatic
leveling takes about 10 minutes.
What is the machine's automatic filament replenishment function
like?
1. It automatically detects materials with RFID recognition, identifying the same material and color
without any operation (default automatic replenishment).
2. It can be manually set to the same material and color without any operation (default automatic
replenishment).
3. It can be manually set to require automatic replenishment.
What is the purpose of the filament entanglement and blockage
detection in the multi-color filament box?
During printing, if the filament becomes entangled or blocked, the machine can detect it and
automatically pause printing until the issue is resolved.
How to load filament into the multi-color filament box of the
machine?
1. Place the K3 on the left side of the printer with a spacing of 10-15cm.
2. Insert one end of the signal line 4-pin into the hole on the left side of the external interface of the
printer base, with the buckle facing down.
3. Insert one end of the PTFE tube into the hole at the top of the printer, with the four PTFE tubes
inserted one by one.
4. Pass the other end of the PTFE tube through the wire clamp, with the four PTFE tubes inserted one
by one.
Need help?
Do you have a question about the Kobra 3 Combo and is the answer not in the manual?
Questions and answers