Graphic Equalizer; Dsp Surround System - Aiwa CX-NMT50 Operating Instructions Manual

GRAPHIC EQUALIZER DSP SURROUND SYSTEM
.. ..
..
r-
1~'—–--=
GEQ
GEQ
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
CLASSIC: Enriched sound with heavy bass and fine treble
Press one of the GEQ buttons.
ROCIK/ POP / CLASSIC
To cancel the selected mode
Press the selected button again. "GEQ OFF is displayed,
To select with the remote control
Press the GEQ button repeatedly. The GEQ mode is displayed
cyclically as follows.
r
ROCK— POP— CLASSIC— GEQ OFF
(cancel)
1
Using the headphones
Connect headphones to the PHONES jack with a stereo standard
plug (a6.3 mm,
'/4
inch),
No sound is output from the speakers while the headphones are
plugged in.
When the headphones are plugged in, the SURROUND system
and the DOLBY PRO LOGIC are canceled.
Sound adjustment during recording
The output volume and tone (except BBE) of the speakers or
headphones may be freely varied without affecting the level of
the recording.
SURROUND
——=====+
f-- (
a 0"- -
'2- r
ac2c2c2
> .-.
g?gg .- -MANUAL
,... -..;~ Q QQ
SELECT
--
The DSP (Digital Signal Processor) surround system can recreate
the effect of sounds reflected from walls or ceilings. This system
enhances 3 m of sound presence.
DISCO: Sound presence of a disco
LIVE: Sound presence of a live music performance
HALL: Sound presence of a concert hall
Press one of the SURROUND buttons.
DISCO / LIVE/ HALL
Equalization curves are selected automatically to match the
SURROUND modes and can also be selected or turned off to
suit your preference.
To select with the remote control
Press the SURROUND button repeatedly. The SURROUND
mode is displayed cyclically as follows.
DISCO — LIVE — HALL — SUR OFF
(cancel)
When the music source is monaural
Select LIVE to obtain a simulated stereo effect, When DISCO or
HALL is selected, no sound will be heard from the surround
speakers.
To cancel the selected mode
Press the selected button again. SUR OFF is displayed.
While SURROUND mode is off, no sound is heard from the
surround speakers.
To adjust the volume of the surround speakers
Press the MANUAL SELECT button twice on the remote control.
"SUR is displayed for 2 seconds.
Press the - DOWN or UP
~ button on the remote control within these 2 seconds.
The Dolby
Pro Logic surround speakers level is also changed.
(See page 17,)
m
The SURROUND mode is canceled when:
- the MIC or ECHO level is changed.
- the DOLBY PRO LOGIC is turned on.
- the headphones are plugged in.
When playing back a tape recorded with BBE, it is recommended
that BBE be set to off to avoid distorted high frequency sound.
7
ENGLISH