Watts Enware Wellbeing WB-BSNTYPA-HE Installation And Maintenance Instructions

Clinical type a wash basin

Download this manual

Wellbeing

Installation and Maintenance Instructions

WB-BSNTYPA-HE

Enware products are to be installed in accordance with the Plumbing Code of Australia (PCA) and AS/NZS3500.

Installations not complying with PCA and AS/NZS 3500 may void the product and performance warranty provisions.

Reference should also be made to the Australasian Health Facility Guidelines (AHFG), ABCB and Local Government

regulations when considering the choice of, and the installation of these products.

This product must be installed and commissioned by a qualified plumber.

For use with potable water only.

NOTE: Enware Australia advises:

1. Due to ongoing Research and Development, specifications may change without notice.

2. Component specifications may change on some export models.

I00626_14 May 2024

1300 369 273 | info@enware.com.au | enware.com.au

Clinical Type A Wash Basin

Need help?

Do you have a question about the Enware Wellbeing WB-BSNTYPA-HE and is the answer not in the manual?

Page 1 Wellbeing Clinical Type A Wash Basin ® Installation and Maintenance Instructions WB-BSNTYPA-HE Enware products are to be installed in accordance with the Plumbing Code of Australia (PCA) and AS/NZS3500. Installations not complying with PCA and AS/NZS 3500 may void the product and performance warranty provisions. Reference should also be made to the Australasian Health Facility Guidelines (AHFG), ABCB and Local Government regulations when considering the choice of, and the installation of these products.
Page 2 DIMENSIONS ”32mm” waste G1-1/4 BASIN WASTE BASIN FIXING KIT Not to scale. Dimensions are nominal and subject to normal ceramic manufacturing variations due to the nature of the manufacture of vitreous china. www.enware.com.au Page 2 © Enware Pty Ltd...
Page 3 Components included: basin, fixing kit, waste INSTALLATION 1. Ensure there is adequate wall structure and suitable reinforcement behind finished wall for basin fixings at the required height position. 2. Prepare water and waste outlet points. 3. Position basin at the required position, level, and mark anchor holes.
Page 4 - WATTS AUSTRALIA EFFECTIVE FROM 20 November 2023 3. Our responsibilities This Warranty Statement applies to products supplied by Australian Valve (a) In the event that the Supplier is reasonably satisfied that there is a Group Pty Ltd (ACN 068 227 270) (AVG) or Enware Pty Ltd (ACN 662...